2. amps-preamps
  3. 1273527546

"Crack" sound in left speaker tube amp

Hi everyone,
I'll try to be as precise as I can be, but I'm not a native english speaker.

First of all, here are the specs :
Power tube Amp - PrimaLuna Prologue Five
Tube Preamp - Shanling MC30
Scandyna "The Drop" Speaker + "The Ball" Subwoofer

Since a few weeks, I can hear a "craking" sound on my left speaker everytime I switch on the Power Amp. I know the problem comes from there because if I connect the speakers to the Shanling MC30 only, the problem doesn't appear.

What does it sound like ? Well, it's like if you unplug a jack from a switched on amp, you know ? This harsh sound that feels like something is tearing apart... When it happens, the speaker seems to shrink in, then out, following this noise, and the sound gets a little lower, mushy.

The noise often occurs some 5-10 minutes after the Power Amp is on, as if it came only after it had heated up. Then it happens every 5 seconds perhaps. And everytime it sounds really scary..

I've tried everything so far : I unplugged everything but it's still the same...

I don't know what to do, I didn't come accross anything like this on any forum. Is it a known issue ?

I hope someone here will have a magical answer ; I always receives great help from you guys !

All the best.
Franz
abalem
abalem OP
10 posts
 
Wow ! I hadn't noticed there had been so many answers yet, thank you !!

I managed to isolate the problem : one of the KT88 was faulty, I switched the tubes by pair and could identify the problem right away.

Hey, hey, a bad for a good : I ordered a quad of Shuguang KT88-Z, and now I'm thankfull this factory tube passed away ! :)

Just hope it didn't hurt my speakers though...
abalem OP
10 posts
 
Oh, and I have to say that tapping the head of the tube with a pencil (very gently I must add) did the trick as well !
trelja
3,224 posts
 
Agree that it very well might be a tube. Swapping tubes will tell you in very quick manner.

However, if you find out that isn't the problem, another possibility is that it's actually the tube socket. I've seen this many times. Today's tube sockets often do not make the best contact with the tube pins, and in the "cold" state, the contact with the tube pin can be compromised. Within the first few minutes of operation, as the parts heat up, they expand, and then everything is fine. If you deduce this is the problem, use something like a toothpick to gently bring the contacts of the tube sockets together a bit, after that, the problem should be solved.

Another possibility, though more remote is a less than ideal solder joint, but explore the tube and tube socket scenarios first. Beyond that we get into issues that the average owner must seek outside help to resolve.
More to discover