Need help fast - Unbalanced Preamp to Balanced Amp

Thank you Mitch.

What a useful information! I also have single ended preamp (Joule-Electra LA-300ME) and Spectron balanced monoblocks.

I did not understand your comment exactly:

"single-ended IC's to two separate single channel Jensen input transformers then very short balanced IC's (less than 1M) from the transformers to my balance "

Left and Right preamp RCA outputs can have only one IC each. If you need for each one of them two separate single channel input transformer then, as I understand it, you need to use "Y" connector at the end of each of your single ended SE interconnect to connect to two separete single channel transformer inputs

is this what you have in mind of each of your single channel transformer has one input for RCA and one output for XLR?

Thank you

is this what you have in mind of each of your single channel transformer has one input for RCA and one output for XLR?

Dob, yes there would only be one rca cable for each channel, connected between the preamp output and the input side of the transformer. And of course one xlr cable for each channel, connected between the output side of the transformer and the power amp input.

As Mitch indicated, for an "input transformer" the xlr cable should be very short, less than 2 feet iirc.

Jensen's site indicates that before ordering it is usually best to speak with them directly, for help with model selection and other guidance.

Best regards,
-- Al

Dob, I could have been clearer. Al nailed it above.

Most of the pictures on the Jensen site show their ISOMAX transformers in a stereo box (both channels into and out of one box). After asking them, they set me up with mono transformers (only one channel input and output per box). Jensen most commonly sells these single channel transformers to their pro clients and the boxes are more heavy duty, but the transformers are identical to the stereo model. The single channel boxes were better for my monoblocks since the amps sit about 7 feet away from each other. If I had used the stereo box, the XLR cables from the box to the amps would have been longer than I wanted them to be. Al's comment on length is perfect, mine are about 2 feet long, and Jensen recommends as short as possible and no longer than about 1M.

Most line transformers, including the ISOMAX are designed to load at 600 ohms or thereabouts.

If you don't load the transformer it can ring. The best place to load it is at the end of the interconnect that it is driving, if that is an XLR you can run that cable 50 feet if you want to with no degradation. I've never in 40 years heard of a requirement to keep XLR interconnects short unless its for cosmetic purposes.

Hi Ralph,

See the following datasheet, and the note near the bottom of page 1 of the user manual for the PI2XX (the unit shown has balanced inputs and balanced outputs, but a similar model can be ordered with unbalanced inputs):

Datasheet: http://www.jensen-transformers.com/datashts/pi2xx.pdf

User Manual: http://www.jensen-transformers.com/datashts/pi2xx_usr_man.pdf

Note that the recommended load impedance range is 10K to infinity. And that the output impedance of the transformer at 1kHz, with a 600 ohm source impedance connected, is very high at 4.65K, of which 1.9K is dc resistance.

Given the very high output impedance, it would seem to make sense that cable capacitance should be kept very low, to avoid high frequency rolloff. That would apply whether the output is balanced or unbalanced.

Your comments appear to be applicable to output transformers, such as this one, which as explained in this application note will not perform as well in terms of cmrr as will an input transformer.

Best regards,
-- Al