Need help fast - Unbalanced Preamp to Balanced Amp

Hi Al, I would not use that transformer for this application, because it does appear to leave you susceptible to the cable due to the high impedances involved.

Instead if you are running a single-ended preamp to a power amp, I would use something that steps down to 600 ohms, and then see if I had enough output at the amp end- if not I would step it back up again.

Of course, we could be talking at cross purposes, the main reason I use balanced lines is to get rid of the need for expensive and often short cables!

Thanks Al, I had not noticed the impedance information in the literature. I would be interested in a more thorough reporting of the output impedance of the transformers at different frequencies resulting from a range of input impedances. The output impedance of my preamp at 1k ohms is low, at about 250 ohms, but rises at lower frequencies due to limited coupling cap size. Although my amps fortunately have a relatively high input impedance of 100k ohms, at lower frequencies approaching 20 hz, the output impedance of my preamp may exceed the 2k ohm "maximum" posted on Jensen's website. I suspect I may be getting some LF roll-off resulting from this. This condition could explain why my balanced preamp performs better in the bass than my single-ended preamp running through the transformers - although there are also other possible reasons for this such as the balanced preamp having higher gain and being SS, while the single-ended preamp is tubed (although it is noted for it's robust bass). I need to find a fully balanced (not pseudo-balanced) tubed preamp that I really like, but have not yet done so.

Hi Mitch -- Assuming you are referring to the LAMM LL2 Deluxe, you've most probably seen JA's measurements, which indicate an output impedance rising to 3.3K at 20Hz. A phone call to Jensen sounds like it would be in order, to ask them what effects that would have.

Best regards,
-- Al

Mitch2, my advice if you look for a preamp is look for one that is fully differential and balanced internally, not just at the inputs or outputs. If it is built right, the length or quality of the interconnect will be of no consequence.

Hi guys, interesting thread, but since I don't understand most of the the tech stuff in the links posted above re jensen transformers, could any of you guys tell me what would be the best way to connect the BALANCED output of my CDP (Simaudio Moon Eclipse) to the UNBALANCED input of my preamp (Hovland HP100)? The CDP also have unbalanced outputs that I'm currently using, but the manual states that the balanced ones sound better, would this arrangement take advantage of these sonic benefits?
Thank you all,
Marco