2. amps-preamps
  3. 1284753562

matched quads, one dead, then what?

My search skills have failed me: if you have a comparatively new (~100hrs) on a new matched set of quads (in this case, winged C EL34's), and one of them dies...is the theory that you replace the whole set of tubes? Or do/can you send one of the functioning ones in to be tested, and have the replacement tube matched to it?

This is why I've started with an inexpensive tube amp, and affordable tubes. :-)
soundgasm
soundgasm OP
152 posts
 
Perfect - Thank you Mlsstl.
soundgasm OP
152 posts
 
...and this kind of seemingly random, premature tube failure is to be expected once in a while? Or is it a symptom of something else in my amp. Bias is correct, and audible performance was fine until the tube went.
newbee
4,751 posts
 
Mlsstl is correct assuming you actually needed a matched quad to begin with. If you have to manually bias each tube in your amp, you really don't need a matched set. The biasing process will take care of variations. Matched don't hurt though.
cmalak
681 posts
 
...and this kind of seemingly random, premature tube failure is to be expected once in a while?
Yes
rodman99999
6,035 posts
 
One of the reasons I purchase my output tubes(matched octets) from Upscale Audio, is the fact that they record all the measurements on the boxes. That would make it a piece of cake for Kevin to perfectly match any tube that had prematurely failed. None have, in the 10+ years that I've been dealing with him, though.
More to discover