Rogue Audio 99 or CJ Classic Preamp?

Regarding the Silverline SR-17.5 speakers, I have a pair in my listening room and have listened to them on both Tempest-II and M-180 systems. To me they sound better on the 8 ohm taps.

This is an aside, but I upgraded the capacitor in the crossover in the SR-17.5 to Duelund VSF. I used Mundorf for the resistor. The improvement is phenomenal.

I actually sold my SR-17.5's to a friend but he won't be able to pick them up until the first of the year. I sold them to help fund my acquisition of Silverline Boleros and when I have the spare funds, without a doubt I'll upgrade the crossover in them to Duelund as well.

Reynolds,
This is great info; thank you! I set the impedance back to 8 Ohms and so far I like what I'm hearing.
Regarding the crossover; did you do it yourself or did you have the dealer do it for you? Also, where did you get the parts from and how much did it cost?

Since you're open to other brands, consider either Musical Design or Modwright. Simple, customizable, affordable. I recently replaced my Musical Design SP2-B preamp with a new (and higher level of modification) SP2-B. I auditioned the older one in a friends system who was running a Rogue 99 Magnum. He only had to listen for a couple of minutes to hear the difference. He bought my preamp, sold his 99 on Agon, put $500.00 in his pocket, and has a better sounding system. It doesn't look as fancy as it did, but it does sound significantly better.

Actusreus,

You are quite welcome.

I did the crossover myself. If you are reasonably handy with a hot glue gun and a soldering iron, it's not difficult. In order to fit the larger capacitors on the board I made a little bridge. Please send me an email and I'll send you a picture of what I did. I'll be happy to make the bridge for you and send it to you. In this case the pictures I send you will be worth a thousand words.

Also, the pictures I have will show the Mundorf silver/gold/oil capacitors that I put in the speaker. However, I ended up not liking the sound and changed them out for Duelund capacitors and they sound great.

Again, please send me an email and I'll send you links and pictures.

The 3.3 micF Duelund VSF copper caps are about $200 each at partsconnexion.com, and you'll need two.

With the Mundorf s/g/o caps I used two 1-ohm resistors in series to give the required 2-ohm total. When I switched to Duelund I was also going to switch to Duelund resistors but broke one of the Duelund resistor leads when I was putting the crossover board back in the speaker. So, I just reinstalled the Mundorf resistors. The Mundorf resistors are $15 each, and you'll need four of them, 1-ohm each.

So, the project will cost about $460. I got the Duelund caps when they were on sale - I don't recall exactly, but I may have paid $170 each for them.

Oh, and you'll need some solder. I used WBT. If partsconnexion doesn't have any, I'm sure Madisound.com would. That'll take the cost of the project up to about $500 I guess.