2. amps-preamps
  3. 1301343815

Power cord for CJ MF2500A

I have a Conrad Johnson MF2500A amp and it sounds really good. My only problem is the power cord is about six feet and it won't reach my wall outlet so I have to plug it into a power strip. Has anyone ever had an IEC bracket installed to allow for an after market power cord? If so, was there any improvement in sound? I'm more concerned with the ability to plug directly into the wall outlet than I am about using a different power cord. The supplied power cord works quite well and I have read that Conrad Johnson spent time developing the right cord to go with this amp.
jimmymac
shum3s
9 posts
 
I am must say that I really could not detect any audible difference after I installed the IEC socket in the amp. What motivated me to do this in the first place, Is that I was told that I would get 20 percent more improvement by using a aftermarket cord from my dealer. I cannot verify from my listening experience that there was a 20 percent improvement. But I do not regret from doing the modification; it was fun doing it and it dose give me more options to experiment. Sam
hifigeek1
770 posts
 
If you live close to the west coast I can accommodate you. I have replaced power cords on C/J's in the past with custom power cords. The problem with putting an IEC socket on any amp is space. I have an IEC hole punch, it's quite large, and therefore space is needed where the hole is to be punched in order to use it. There usually isn't enough space.
cellorover
426 posts
 
The "hospital cord" is very good. It is comparable to other power cords in the $1000 range. If you are handly with a soldering iron you can change out the stock cord for the CJ hospital cord. As once asked, where are you located?
jimmymac OP
101 posts
 
I'm in San Francisco.
hifigeek1
770 posts
 
I'm in so cal and authorized C/J service...
More to discover