Is this enough power?


Does a 30w per channel 845 SET amp have enough power to drive 88.6 db at 6 ohm speakers at moderate level of volume. room is 14x18x9 and open at one end into the kitchen. mostly listen to jazz and classical.

Thanks
audioman999
Magfan - is there anywhere i can go to find out more about phase angles. that is something i am not familiar with. Does it have something to do with the slope of the impedance curve at a specific frequency?
That does help and the amp will work. I still caution you that more watts would help your system reach it's full potential.

This will be true on all classical recordings that happen to have low output levels. Your room is large with the kitchen figured in and 30 watts won't let you realize the full weight, scale and impact of your music.

I also found this and used google translate. Is the frequency response and/or axel deviation comment related to phase angles? Not sure if the wording is different because of the translation.

"Also by measurement the relationship between S-1EX and S3-EX is unmistakable. The frequency response looks almost like drawn with a ruler and extends down to about 40 Hertz. From five kHz is a slight ripple into play when the axial deviation of 30 degrees (dashed line), however, is negligible. Straightened out into the room, the Pioneer actually sounds a bit faster and more coherent dunk. The impedance is danzverlauf critical, and the jump response is in order, with the enormous time accuracy of their sister, it can not record the S-3 EX bass but because of the delay."

Thanks
Phase angle is how much current leads or lags voltage.
In a pure resistive circuit they are in sync.

The wiki has some good illustrations.
http://en.wikipedia.org/wiki/Power_factor

For stereo / hi fi, this presentation is most useful
http://www.hometheaterhifi.com/component/content/article/228.html

The main thing to remember is that any time current and voltage are not perfectly in sync, less power is delivered to the load.

It is pretty much purely electrical. Maggies for example, if you simply look at impedance may be considered a difficult load. This is not necessarily true, since the phase angle is moderate thruout the frequency range. Other low sensitivity speakers which like tubes may be like the Harbeth.

Here is a good example of a fairly large phase angle coupled with a low impedance dip. I don't know if these guys work well with tubes, or not.

http://www.stereophile.com/content/focal-chorus-826w-30th-anniversary-edition-loudspeaker-measurements
The phase angle is not a single number or a set of numbers. The data will be in the form of a frequency response graph, but with + and - phase angle on the vertical axis. Stereophile prints such data on the same graph that plots impedance at various frequencies. What makes a speaker difficult to drive would be an extreme phase angle (e.g. -45 degrees) at a point where impedance is at its lowest point, and particularly if such combination is at a frequency with a lot of musical energy (e.g., 80-200 hz).

Fortunately, reports like that of Stereophile, will not only provide data but an interpretation of its meaning so you don't really have to know how to read the graphs.

My guess is that 30 watts may work, provided you don't play the system at really high levels. For reasons I don't quite understand, I find that distortion from a shortage of power will be most evident on works with a large chorus. At a subjective level that does not seem that loud, a work like Rachmaninov's Vespers may begin to sound distorted if your amp is not fully up to the task (maybe its because human hearing is most sensitive and tuned to the human voice). If you get a chance to try the amp, bring along such works.

One of the advantages of a good SET amp is that they are quite musically satisfying and sound right at lower volumes so you probably would not really need to push them that hard. I personally don't mind trading off the rare times when I really want to play the system at extreme volume in order to get the desirable characteristics of a good amp for 99.9999% of the time.