Replace pwr cord w/IEC socket on vintage gear?

"With vintage equipment it is more important to make sure the polarity is correct when you plug it into the wall outlet"

power cords on stock vintage gear can be plugged into an outlet either way theres no difference in the size of the prongs like on modern cords. it dose not matter which way they are plugged in. im talking about 60s and earlier not 80s which i dont consider vintage.

its up to the owner which way to go IMO those as mentioned 16/18 gage power cords do not do justice to those fine music making machines from the golden age of audio. if its the music and not collecting thats important i go with an iec every time.

Paying near $90 for IEC + spending another $100 for aftermarket powercord isn't worth effort. Having IEC will just be another contact connection instead of solid joint wire. DIY is OK if you're savyy. If powercord is bad, than you can replace it with one having same parameters from either partsexpress or digikey. There are ones for audio applications shielded that would do great job for less money.

Johhnyb53, I had to make this same decision with my ARC D70Mk2. I went with all stock and I'm glad i did. A friend who bought a D115 Mk2 changed out the stock cord with an IEC and a Shunyata and also changed the speaker cable strips to the newer Cardas connectors along with the RCA's. For some reason, we both were very disappointed with his results! The amp seemed to loose some of its ability to portray depth and a little of its punch in the bottom end. A big surprise as we both thought that these areas would likely be improved. My friend then tried to sell the amp and found out that the market was calling for a non-modified unit and so he ended up selling for a little less than hoped for..:0(

Stltrains, You are mistaken. There is a right way and a wrong way to plug in vintage equipment. Without any other equipment connected to the subject component plug it into the wall outlet and take a voltage reading from the chassis to ground. Then turn the plug over and take another reading. Whichever reading shows the lowest voltage is the correct polarity. When vintage equipment is plugged in the correct way they sound modern. When plugged in the wrong way they don't.

Has anyone ever been shocked by an old refrigerator when you were a kid? If you did it was because it was plugged in the wrong way and there was too much voltage riding on the chassis. Turn the plug over and no shock.

It's not a matter of personal preference. There is a right way and wrong way.

There are a lot of classic power amps from the '80s, with captive power cords--Electron Kinetics Eagle

I've never seen an Electron Kinetics Eagle with a captive power cord. I've had7 of them, and seen dozens more and they all have an IEC connector.

I've installed IEC connectors of many vintage amps and never had an issue reselling them. Further, it's a tedious job - 1 hr labor is not a bad deal.