Sub connection to CARY SLP-05 preamp

Impedance is usually well wihtin range with parallel downstream loads. However, adding to the complexity, I am using the fully balanced modwright 36.5 to drive my subs and mains, and the manufacturer explicitly advises against using RCA and XLR at the same time, because it will create an uneven load on the output transformer. I presume the Cary would have the same issue. So you either use 2 RCA outputs or get a high grade XLR splitter to split your XLR output (only possible if you subs have XLR inputs of course). Purist audio design makes a beautiful XLR splitter, which is an adaptor with no cable.

Edorr,

Don't you agree what Almarg suggested about feeding a pair of speaker cables from Amp to Sub speaker level input? And also why he does not suggest to do what just say. Can you explain in case you think your way is better?

I think that the problem with tapping a DD sub off the main power amp is that (AFAIK) you can't use the RTA/Room EQ function that the sub offers in that configuration - unless I'm reading this wrong (always possible!) In my book, the Room EQ is probably the single best reason to use the sub in the first place (particularly with your speakers).

Incidentally, I assume that the 2 channel pre-amp indicates a music only system. In this case, I'd think that any roll off at the bottom of the sub's passband is unlikely to be very important, since there isn't a lot of music program info that low in pitch (and it can be EQ'd back, anyway, if you really want it).

If Cary says that running RCAs and XLRs concurrently is a no-no, I'd go the XLR splitter route described by Edorr.

Just my take.

Marty

09-12-11: Edorr
... I am using the fully balanced modwright 36.5 to drive my subs and mains, and the manufacturer explicitly advises against using RCA and XLR at the same time, because it will create an uneven load on the output transformer. I presume the Cary would have the same issue.

My posts about the SLP-05 were based on the assumption that its outputs are capacitor coupled, as is the case with most tube preamps, and not transformer coupled, as is the case with your Modwright. I was also making the assumption that its rca and xlr outputs are driven by independent output stages, which is why I used the word "probably," in capital letters, when I referred to the impedance reduction that would result from driving two line level loads in parallel as "probably" not being applicable to the SLP-05.

If the Modwright drives rca and xlr outputs from a common output transformer, presumably with a grounded center tap on the secondary winding, and one end of that winding going to the rca center pin, that is a completely different story, and you were correctly advised.

Regards,
-- Al

Al, thanks for explaining.

Grandtech, probaby wise to check with Cary as Marty suggested. Regarding your other question, I'm also with Marty on using speaker level inputs. You want to use EQ with the subs if at all possible which such a setup would preclude you from doing. I am not even sure how you would use the Xover build into the DD-12 on a speaker level signal. I could be wrong here but I believe the Xover works on the line level input. This would make this a complete non-starter, since you need to apply a low pass filter.