Russian 6C33C Tube Testing and Matching


I have 10 of these beauties that require testing and matching etc.

Any suggestions on where I can send the tubes for testing and matching for a fee?

I need matched pairs for my Quicksilver Triode 6C33C Mono amps
mdominguez
baaaaaa! Wrong answer. 6C33C take special tester. Doubt you'll find any radio, TV, guitar shop with one. There is a person on this forum who sells them, tested, for $60 a piece IIRC (just do a search in classified section). Perhaps he might be able to test for you. Also, I used to purchase them at PartsConnexion.com, which also tested them. They might help as well.
The only way is to built a special jig for testing them or using an existing amplifier to measure them - it is risky if you do not know of their condition.

The main problem is supplying the needed high filament current (3A at 12,6V) - no usual tester can supply it.

Check with TC Tubes. He offers a tube testing service using the Amplitrex AT1000, one of the best, if not the best tube tester available. This will test the 6C33C. A good friend bought some KT-88's from him, and was very pleased.
Good advice. But understand he must charge you something for this service - the Amplitrex AT1000 costs more than usd 2500.

From the specs of the AT1000
Heater/filament power from 1.0 to 12.6V, up to 3.5A
The 6C33 tube is extremely hard to test. The reason is its highly pronounced positive thermal feedback, turning any fixed bias testing into a test of your nerves. In reality I only recommend testing it using a servo-controlled bias circuit.

Barring that, your best bet is, in my view, to buy the tubes from the manufacturer, or to ask them to test your tubes, is they agree to do that.