bridging integrated amplifier

" Connecting both channels together will almost certainly destroy your receiver."

Depending on some other factors but this is how our stereo amp work in fully balanced monoblock mod and no amplifiers were destroyed yet but I would not bet against human creativity - one day I surely will be surpised!

Most probably will be either near silence or actually somewhat distorted sound: the last depends on parts tolerance in both channels which is rather expensive or very, very expensive.

The best if OP will ask manufacturer in question directly - they have great name and surely will advise professionally

All The Best.
Simon

The bridging wiring technique to take the positive from the receiver's right channel and connecting to the positive terminal on the speaker, then take the negative from the receiver left channel to the speakers negative terminal. The speaker is 8 ohm so the load should drop to 4ohms. I'll reach out to NAD also...

01-13-12: Rome2000
The bridging wiring technique to take the positive from the receiver's right channel and connecting to the positive terminal on the speaker, then take the negative from the receiver left channel to the speakers negative terminal. The speaker is 8 ohm so the load should drop to 4ohms.

That is not bridging, nor is connecting the outputs of the two channels together which is what I believe Simon was addressing.

I suspect that your NAD, like most amplifiers or receivers that do not have balanced outputs, has the negative output terminals of both channels connected together internally. Therefore the connections you are proposing would make no difference compared to connecting the speaker to the output terminals of one channel.

Bridging as properly defined (for an amplifier having unbalanced outputs) involves connecting the speaker between the two positive output terminals, with no connection to the negative terminals, and having one channel of the amplifier process a signal that is inverted with respect to the one being processed by the other channel. That will usually result in a large increase in the amount of power that can be delivered into an 8 ohm load, because as a rough approximation it would double the range of output voltages that the amplifier can provide. However, it is not usually practicable to do that unless the amplifier design specifically provides for it, and according to the manual your NAD does not.

Regards,
-- Al

Rome2000, contacting Nad sounds like a good idea as mentioned above, if you really think it can be done. But, bridging your receiver would not be a good idea in my opinion either. If it would work, it would change the impedance to 16 ohms, not 8 ohms. Definitely don't try it, without asking NAD first.

Receivers don't normally have do not have balanced outputs to my knowledge, and are not capable of bridging.

Bridging a lot of amplifiers is not an option either.

I've never seen a receiver that has outputs that can be bridged, at least that I can remember. A company that makes amplifiers commonly will tell you the option and mention its connections in the manual, but I don't see that in your manual, that's available to everyone on the net. A lot will print it on the amp (receiver in this case) by the speakers connections.

Maybe Spectron has some unique designed receivers.

If you want both channels output through a single speaker rated at 8 ohms, you could just connect it conventionally via one set of speaer terminals, then set NAD's speaker impedance selector to 8 ohms, and then press the "Mono" selector button on the front right panel of the receiver, to merge stereo signals into a single mono output.
Do you actually need to double the power output, anyway?