Is there any truth to this question?

02-13-12: Digepix
Here's another one: Harbeth speakers, less sensitive than my Vandersteens and are an easy load for amps to drive my YBA amp is a great match for them ...

If the Harbeth's were similar in their frequency response and impedance characteristics to the M40.1, for which John Atkinson's measurements are shown here, there are a couple of factors which probably contributed to that.

First, their near-field frequency response has a 7 db peak at 70 Hz, relative to the response at 1 kHz, and a smaller but significant elevation throughout the mid-bass region. Those are the kinds of frequencies where most music has its greatest energy levels. A 7 db rise results in the same sound level at the particular frequency that would occur if there were no rise but amplifier power is multiplied five times.

Also, as JA notes, "the M40.1's plot of impedance magnitude and phase angle suggests that the Harbeth is easy to drive in terms of its demand for current."

I know of a fellow 'Gon member who very successfully drove an M40.1 with a 32 watt per channel VAC Renaissance 30/30.

Regards,
-- Al

If an amp is clipping, there is a good chance the sound quality is negatively affected well before any any clearly audible distortion is noticed. Better to have an amp that goes loud effortlessly to provide headroom before any clipping comes into play. One might be surprisec what is needed to do this for less efficient speakers. The difference can be subtle but very significant. With the exception of very efficient switching Class D amps, some weight and size is usually required.

02-13-12: Mcpherson
This may be a silly ? but when the term "clipping" is used..Is it referring to the amp shutting down momentarily or the speakers making a clipping sound?

It does not refer to the amp shutting down, momentarily or otherwise. It refers to the rapid rise in distortion which occurs as the amount of power the amp is asked to provide approaches and then exceeds what it is capable of providing.

Regards,
-- Al

This is a question I have had for some time and see no need to start a new thread, but I would like to ask the same basic question this way, and hope get a answer I can understand.

I have 4 ohm speakers being driven by a 150wpc into 4 ohm amp. Say I never go louder than 3 watts. I should have enough power for all peaks and dynamic events.
Say I then replace that 150wpc @ 4 ohm amp with one rated at 300wpc into 4 ohms. I still listen at 3 watts. Will I have gained anything?

Glad to have phase drug into this discussion.

also needed is the fact that while same-power amps will make about the same amount of heat driving a resistor, the same can not be said when driving a reactive load. That's when people start talking about 30 watt SS amps weighing in at 75lb.

So, the Harbeths with minimal phase shift are an easy load, regardless of the overall sensitivity of the speaker.
Similar comments can apply to my panels. Reasonable phase angle, low sensitivity and well coupled into a room make for a reasonable load which any 4-ohm capable amp should drive well. The conventional mo-betta' panel power wisdom may not be 100% accurate.