2. amps-preamps
  3. 1333722427

Pass Labs INT-150 with Power Plant Premier

I just upgraded to the Pass Labs INT-150, which recommends against using an active power conditioner. This amp is currently plugged directly to a wall outlet based on this recommendation.

My entire system in the past, including amps have ran through the PS Audio Power Plant Premier with more than satisfying results.

If anyone can help explain the issue recommending against active power conditioners, I would appreciate it. I have no level of expertise on this type of electrical issue.

Thanks
darkkeys
bizango1
276 posts
 
Seems like you should ask Pass Labs. Whenever I've talked to manufacturers they have been very friendly and helpful.
stanwal's avatar
stanwal
3,147 posts
 
I use my PPP with a CJ 350; which draws more current than the Pass with no problems.
gsself
46 posts
 
The concern would be the abiltiy of the power conditioner to keep up with the current demands of the ampllifer. Reduced current not a problem that's going to cause damage to your int amp so the question is what affect will it have on sound. That is a question that only you will be able to anwer by listening to your system with and without the power conditioner.
darkkeys OP
99 posts
 
Thank you everyone for your input.
wolf_garcia
6,708 posts
 
My wall power sucks...and it's a modern house. I need to see how much it would cost to get dedicated lines. Does Pass assume the wall power is always good? Regenerators seem like a good idea but they are SO damn expensive...I'm using a PS Audio power port ac outlet and my trusty Adcom ACE 515 and getting away with it so far.
More to discover