Granit amp stands are they killing my sound?

Thanks Palasr. I'd like the compressor out of site. I know they can be quiet as I've heard a Jen-Air? at Sounds of Silence, the Vibraplane distributor. I just don't want one in my formal living room. I wish I had a dedicated audio room.

I also have my passive Vibraplane preloaded with one 1 1/8" plate of steel weighing 136 lbs which brings my total load to 250 lbs. I agree, the improvement is very noticeable.

Air is great for isolating a component like a turntable and I'm sure it can be effective with amps. But when it comes to draining vibrational energy away from a component, there may be better solutions. Perhaps the OP is more interested in draining energy with spikes into a massive platform then he is in isolating his amps from floor born vibrations.

Have you tried putting your Galibier up on spikes or cones on top of the aluminum sheets? That may address both objectives.

My turntable rests on four small ball bearings at the center of each adjustable footer. These drain the energy away from the turntable/motor while it is being isolated with the Vibraplane. I have the option of using four rubber inserts instead, but have not tried them yet. I've been told the ball bearings sound better.

Have you tried putting your Galibier up on spikes or
cones on top of the aluminum sheets?

Well, that is the difference between High End and Science. When I go into a Lab
and tell a technician he should use cones below his equipment, he will throw
me out in..well..let's say...30s.
Maximum.
In High End the result is the other way..Cones??? Great idea!!!! They have
different sound? Super! There are cheap ones and expensive ones out there?
GREAT! A piece of paper below them can make all the difference??? WOW, I have
to buy that paper.... Made in a cave in Mongolia for 1250,--$ / square foot?
Deal!
... and so on

I have a VPI Superscoutmaster/rim drive. I found that rubber or anything compliant under the table (as in footers) makes the sound "rubbery". I use Bearpaws...(Vermontaudio.com). They are very heavy brass cones and they really clean up the sound from the VPI supplied minifeet.

I get your point Syntax. Very funny post! Explain what is between your amps
and your Vibraplanes. Also between your MS and Basis turntables and their
Vibraplanes. Do you think a hard ball or point sounds different from some
rubber footer/insert under the components? If they sound different, surely
science is involved.

It would seem possible that granite may not jive with all amps. I would try directly on the floor vs. on the stands. For about a year I had my monos directly on the floor with the intention of some kind of stands. As you all know for anything nice well there's another $300+ each. So I ended up using 3" thick butcher blocks. I can't say it altered the sound in anyway, besides that was'nt the goal. They look fine to me and were on the cheaper side. Anytime I want to play with placement they easily allow for sliding of the amps. I suppose if using some spikes under the amps into the butcher blocks it would help drain any vibrations.