More power for better sound at low volumes?

Not really Mapman, with earphones you loose the open soundstage effect of a well set up system which I value as I know you do as well. Although not stated I recognize that there are speaker designs which depend on reflections for their imaging characteristics (need I tell you? :-)Other than that I find the headphones (mine anyway) very rewarding. I bought 2 sets (headphones and tubed amps) for my main system and, where they really shine, in the TV system where soundstaging is not a big deal.

Newbee, you are right of course.

Check my last post again. I had edited and expanded it to cover that exact caveat.

When you operate a high power amplifier at low power levels quite often you have higher levels of distortion. This is because most high power amplifiers are push-pull and with rare exception, most push pull amps (tube or solid state) will have their lowest distortion at some point well above zero watts and then the distortion increases again as power continues to decrease.

At low power in particular, it really is that 'first watt' that makes the difference! Due to the ear's masking principle, if higher distortion is present, detail will be obscured IOW such an amp will be less detailed at lower volume levels. Also as others have pointed out the noise floor will be higher too.

Amps that do not exhibit this dip in distortion, IOW amps that have a linear decrease in distortion as power goes down to zero, will have unmeasurable distortion as power levels fall below 1 watt. They fall into two categories: either SET, or fully-differential with little or no negative feedback.

I can go into the why of this if anyone wants but it gets technical.

Unsound, more power in the amp will not reject external noise. The way to do that is to have a fully differential balanced circuit (whether tube or solid state).

Listening to most really good stereo recordings on headphones is in fact the stereo equivalent of watching a 3-D encoded movie without the required glasses. Room acoustics are the equivalent of the 3-D glasses for a stereo recording. And of course no two rooms share exactly the same acoustics, including studio or hall recorded in and listening room at home, so the reproduction will most likely always be different to some extent and not exact no matter how "good" the stereo system is.

06-21-12: Unsound
Al, Perhaps erroneously, I would have assumed that "all else being equal" extra power would have provided the muscle to reject external noise from seeping in?

Hi Unsound,

No, I don't see it that way. Higher amplifier power will loosely correlate with higher amplifier gain, since amplifiers tend to be designed such they they will be driven to their maximum power capability, whatever that may be, when their input voltage is in the same general area (commonly, although of course not always, in the general area of 1 to 1.5 volts, for unbalanced inputs).

So as I indicated, any noise that is generated or introduced downstream of the volume control will, more often than not, be amplified by a greater amount if the amplifier is higher powered. (Noise originating upstream of the volume control will normally be unaffected by that gain difference, because the volume control setting will be turned up or down to compensate for the gain difference, affecting the signal and noise that originates upstream equally).

Best regards,
-- Al