Amp preamp impedance matching...can anyone explain?

Is there a limit to how high these ratios or the power-in should go, before it sounds bad?

No, not that I can envision.

Regards,
-- Al

As a simple rule of thumb most any transistor preamp can drive any tube amp.

Its not always the other way 'round as pointed out above. (FWIW we get around the problem by direct-coupling and using paralleled tube sections to obtain a low output impedance that can drive any amp around.)

But if there are coupling caps its a different ballgame. For example, ARC recommends no less than 30K as the input impedance of the amplifier with which the Ref 5 is used.

10:1 is a safe minimum value, but you can go 100:1 and its fine. So in the ARC example above, standard engineering practice suggests that the output impedance of the Ref 5 is 3K ohms. However they are fairly conservative and are showing 600 ohms on their website, although that might be at 1KHz. IMO the 20Hz output impedance tells the real story.

The lower the output impedance, the more the line section can control the interconnect- by that I mean the less sonic attributes the cable will have. So the lower you can get the output impedance, the better (all other things being equal...).

I am really learning a lot from you guys. Thanks.

I was just playing with the thought on the different types of power-amps that my preamp of 20 ohms output, can be connected to! Seems like it will be alright. ;)

I have a tube DAC that uses a single 6SN7 tube with 1 microfarad coupling caps. I was told it has 8 kohm output impedance. I wanted to get this integrated SS amp but the input impedance is 10 kohm. So this is a horrible match, so I stayed away. My tube amp with passive stepped attenuator at the input of the amp has 100 kohm impedance. This DAC/amp combo sounds dynamic as hell with deep bass extension. But I really wanted that SS integrated.

Reading this as well and I wanted to add my specs from my Marantz PM-KI-Pearl Integrated that I would like to entertain using as a preamp and then adding an amp...tube or ss still not determined.

The testing of this Pearl unit shows "The output impedance from the Preamp Out jacks was 217 ohms at high and middle frequencies, rising to 495 ohms at 20Hz."

Based on this information, does one still look for the above in the input impedance of 47k or higher?