Amp preamp impedance matching...can anyone explain?

I am really learning a lot from you guys. Thanks.

I was just playing with the thought on the different types of power-amps that my preamp of 20 ohms output, can be connected to! Seems like it will be alright. ;)

I have a tube DAC that uses a single 6SN7 tube with 1 microfarad coupling caps. I was told it has 8 kohm output impedance. I wanted to get this integrated SS amp but the input impedance is 10 kohm. So this is a horrible match, so I stayed away. My tube amp with passive stepped attenuator at the input of the amp has 100 kohm impedance. This DAC/amp combo sounds dynamic as hell with deep bass extension. But I really wanted that SS integrated.

Reading this as well and I wanted to add my specs from my Marantz PM-KI-Pearl Integrated that I would like to entertain using as a preamp and then adding an amp...tube or ss still not determined.

The testing of this Pearl unit shows "The output impedance from the Preamp Out jacks was 217 ohms at high and middle frequencies, rising to 495 ohms at 20Hz."

Based on this information, does one still look for the above in the input impedance of 47k or higher?

Vineman, since the worst case (20 Hz) output impedance is known, just multiply that by 10 to calculate the minimum desirable amp input impedance.

495 ohms x 10 = 4.95K (minimum)

Nearly all power amps will meet that criterion.

Regards,
-- Al

Thanks for clearing this up here...