Newbie Question: Why is turntable volume so low?

When I posted, the above posts weren't there. If it does have the DL-103 low output cartridge, then you probably do need an outboard phono preamp for moving coil (MC) cartridges. Also, you do need to turn off the preamp in the MAC, if that is the cartridge, and if your going to use an outboard preamp.

The phono amp built into the MAC is for MM (moving magnet) cartridges only. You do need to check the type of cartridge being used.

Hi Guys,

Thanks for the answers, unfortunately, I'm still stuck. Hifitime, I have set the "ZONE A ANALOG INPUT PHON" setting (as opposed to the BAL1 or RCA options in that particular menu) but I'm still at a volume level of around 40 for the turntable (vs. 20 for digital inputs). The BAL1 and RCA options offer almost no sound at all (mostly just hum). I'm just worried that if the volume is at 40, and someone changes to a digital input without turning the volume down first, I'll damage my B&W's.

Your last post mentions some stuff over my head. Do you mean I have to buy an additional pre-amp just for the turntable? Totally uninformed newbie question number 3: Can I just buy another cartridge for the turntable instead (cheaper, no)? A different turntable would also be cheaper, I would think.

Sorry for all the dumb questions guys, but trust me, I'm worth it!

Regards,

Bill

Just get a mm cartridge that has higher output (5mv or more). But your levels will never match exactly the same. Another way to make the levels match is to put an ajustable attenuator between the dvd unit and the preamp to lower the volume of the dvd. This is what I do to make my tuner lower so I don't have that problem.

"I'm just worried that if the volume is at 40, and someone changes to a digital input without turning the volume down first, I'll damage my B&W’s.”

Hi Bill, just a heads up:
It’s a good practice to always rest the volume at its lowest setting after use. And after making sure it’s still set that way, the volume should be the last control engaged when starting up.

Bill, I guess my post from yesterday is not going to show up. I don't think your MX-120 is compatible with your present cartridge.

Rodman pointed out that you may have the DL-A100, which is a *low* output moving coil (MC) cartridge. This is most likely the cause of the low volume problem, due to its low output, if that is what's in your turntable.

There's a lot of difference in the output level/voltage between a moving coil (MC) cartridge, and a moving magnet (MM) cartridge.

The moving coil (MC) is a *low* output. I think this is what you have in your turntable and, most likely the problem. This type would need a separate phono preamp to work with your MX-120.

The moving magnet (MM) is a *high* output cartridge. This type of cartridge should work with your MX-120 with no problem.

I'm leaning toward you either need to get an extra outboard phono preamp for your present turntable/cartridge setup to work. This extra phono preamp would have to work with a low output moving coil (MC) cartridge, like the DL-A100, that may be in your turntable.

The other option would be to get a moving magnet (MM) high output cartridge, that should work with the MX-120's built in phono section.

I should have been more clear. I hope this helps.