2. amps-preamps
  3. 1350004669

Replace volume pot

Hello,
My preamp has a Noble volume pot at 100K ohms.
I like the sound of the preamp in my system so I prefer to keep it. However, I'm having to run the preamp with volume control at almost max rotation to produce a moderate sound level. Also, I like my Monarchy amps and do not want to change these. A friend tracked down a Noble pot (same physical dimensions and pin configuration)at 50K ohms.
I'm hoping to replace the pot and not alter the sound characteristic/performance of the preamp.
Any concerns with performing this swap?
pdspecl
roscoeiii's avatar
roscoeiii
1,155 posts
 
Sounds like you have a problem that a new attenuators will not fix. You need either an amp or pre with more gain.
marakanetz's avatar
marakanetz
5,473 posts
 
Kijanki,

I have to disagree with your general statement as volume pot more acts as resistor. When the volume dial is all the way down, the potentiometer value is all the way up to mute the signal.

In case with OP the value of volume pot won't solve the problem simply because the volume up value of resistor is zero and it will be zero either with 50K volume pot or 250K. 250K volume pot can mute more volume than 50Kohm or another words preamps with larger gain will have potentiometers with larger magnitudes.
pdspecl OP
254 posts
 
Problem is not the volume pot or mismatch from preamp to amp.
I disconnected the XLR cables and connected RCA cables to the the Monarchy amps. My gain has increased dramatically. No more issue. Very interesting that the different cablee configuration runs very different levels on the same amp.
ivan_nosnibor's avatar
ivan_nosnibor
1,052 posts
 
I suspect that your preamp's volume pot would have malfunctioned on both the single-ended outs AND the XLR outs if it were to blame. I'm guessing at this point the fault lies inside the preamp's single-ended output stage. I've run my pair of SM-70 Pro's both single-ended and balanced (through installed Goldpoint attenuators) and there certainly was no noticeable difference in gain, of course. Hope this helps.
ivan_nosnibor's avatar
ivan_nosnibor
1,052 posts
 
Sorry, I mean the fault lies inside the XLR output stage, of course.
More to discover