Audio Research Vs115


I'm look at trading my amp in for an Audio research VS115 tube amp. I'm using a PS audio perfectwave as my source. Anyone had experience with this amp.

I auditioned it yesterday with Burmester B25 speakers and it sounded great.

Love to hear your experiences with this amp...thanks
mherron
Any recommendations for new tube set other than the Audio
Research Brand. Can I use any 100 ohm 1 watt bias resistor
or need to order one from A. R. ? Thanks, Gerald
Have the VS 115
Gerald, for some reason ARC recommends using their parts, e.g., bias resisters. I don't know why. They only charge a buck so per resister. Selling "matched" resisters can't be a big profit center. So, I would order the resisters from ARC.

As to tubes ... I think the main stream brand is Tung Sol KT-120s, but there may be other KT-120 manufacturers. ARC charges about $100 a tube, which is twice as much as what other reputable vendors, such as Upscale Audio and so forth. I've gone both ways with tubes. I don't think ARC's KT-120s sound better than anyone else's KT-120s.

But there are two advantages going with ARC. One ... it has been my experience that ARC does a better job of matching tubes. An ARC matched pair biases very closely.

Two, if a tube arcs within 90 days of purchase, I believe ARC will replace it. They may also repair any damage caused, e.g., open bias resister. I'd check the last point.

Btw, I used to own the VS-115. Traded up for a Ref 150. I think the VS-115 is a super-duper amp. Enjoy.

Bruce
ARC recommends using their parts especially when it comes to the resistors around the output tube circuit because they are flameproof wirewound resistors. These parts are used to minimize circuit board damage when an output tube arcs. Instead of using a plain wirewound resistor where the resistor might heat up and scorch the board, a flameproof resistor basically pops and opens thereby minimizing damage.