Center Channel Speaker Question

If your dialogue alone is hard to understand it may be more of a "lip sync" issue. Try closing your eyes and if the dialogue is now understandable then its a lip sync issue. I know it seems crazy to try but if your lip sync is not adjusted correctly than your brain has a harder time with understanding the dialogue because the lips start moving before the corresponding sounds come out of the center.

If it is still an issue than pursue matching your front speakers.

"Sorry to disagree, but B&W states the impedance of the LM1 as 8 ohms with a minimum of 3 ohms. Using a pair on a single channel will result in a 4 ohm impedance with a minimum of 1.5 ohms. The recommended minimum impedance for the SR-6004 is 6 ohms. It just seems too risky, mainly because of the severe drop to 1.5 ohms. I would talk to Marantz tech support before attempting to use a pair of LM1’s on the center channel."

Not if you wire them in series. Also, if you use 2 speakers, you won't need as much volume. It will definitely work.

Its easy enough to test what I'm talking about here. The OP can just take the pair of LM-1's that he already has and hook them up to one channel on his amp, and do some listening.

Thanks for the response. It appears that all agree I don't necessarily need to purchase a true center speaker. Usually the LM1 come as a pair so my curiosity is piqued. Zd542; Am I correct in understanding that all I need do is use center channel wire, hook up 1st LM1 and continue wire to 2nd LM1 effectively wiring in series? If the result is not pleasing then I can fall back to using 1st LM1 as center. If the "series" setup does no harm then why not try it? Wired in series,will there be a "volume drop" between the 1st and 2nd LM1?

Your receiver has Audessey. Try to turn the dynamic EQ on. It may boots the midrange up a bit. You may get away of buying new speaker.

"Am I correct in understanding that all I need do is use center channel wire, hook up 1st LM1 and continue wire to 2nd LM1 effectively wiring in series? If the result is not pleasing then I can fall back to using 1st LM1 as center."

No, that's parallel. You can try it that way but your amp may strain a little. For series do this: 1. Connect a speaker cable from the + on your amp to the + on one of the speakers. 2. Connect a speaker cable from the - on your amp to the - on the other speaker. 3. Run a speaker cable from one speaker to the other connecting it to the unused binding posts.

As far as the volume issue goes, I meant that using 2 speakers for the center will take the demand off 1 speaker used as a center. That's why I suggested the test in my first post. Listen to some music just using your main L and R front speakers. After a minute or so, just unplug 1 of the speakers and listen to it. If you do that, you will see immediately what I am talking about. Just listening to the 1 speaker play music, you will see how hard that single speaker has to work to keep up with the main 2. Its just a rough test. When you are watching a movie, different info is sent to the center channel, so the test isn't 100%. That said, its still a very good indicator as to how the front and center speakers interact with each other.