how to set up a tonearm/cartridge

Thanks folks for your help, I will try to find the cause of the problem, please do keep sending me more ideas on how to find the remedy.

If the distortion is mostly in one channel, try adjusting the anti-skating as follows. If distortion in left decrease A/S, if distortion in right increase A/S. If the distortion is equal in both channels then the problem is likely with the arm/cartridge alignment (use a gauge to check this) or else the tracking force may be set too low. Good luck and please let us know what you find.

Check the following:
1. Is the turntable level?
2. Is the Armboard level (when it is not original Micro Seiki)?
3. Is your adjustment right (Pivot to Spindle)
When that is all right, then you have a problem with your Arm
The 3012 can't handle all kind of cartridges, it is not really good in energy transfer (vibrations in its bearing), normally it runs well with ultra soft suspended cartridges...when nothing helps, go for a better Design, FR-64s. That Arm is a total different chapter.

Hi,

just a quick note that I have put a new video on YouTube. Once everything is ok with your deck and you have finished your work on overhang and zenith you should not forget about azimuth;)

Look here: http://youtu.be/y5UGd2E9s9Q

Hope this is not too offensive to post this here but I thought if not here where then?

Cheers,

Chris

Deare Marcell728: Other issue with your Ortofon cartridge is that's a poor tracker with a low compliance: 8cu, that's why those 4.0grs on VTF.. So you can expect to have a lot better results after checking the tonearm/cartridge/TT set up.

Any bad tracker cartridge not only give us some kind of problems at the inner grooves but normally at microscopic level when reading the recorded information it can't recovery the full information due that normally because that poor traking characteristic don't stay 100% in touch with the grooves and this happen not only at the inner grooves.

Now, if that kind of sound is what you like it then that is part of the trade-offs that exist in all audio items, there is nothing perfect.

According with Ortofon specs that cartridge can ride safely at 5.0grs as top/superior VTF limit. You can try it and see what happen.

Regards and enjoy the music,
R.