2. tech-talk
  3. 1173389331

one channel dead as a door nail

Put on my rig like I always do. First I fire up my Bel Canto SEP1. Takes 20 seconds than I put on my Bel Canto SET40 amp. Since my tuner is always on the sound comes on in a few seconds. Everything is cool until I turn on my cdp. A not too loud crackle/pop. No sound out of one channel now, whether it be tuner or cdp. Help
warrenh
mcfarland
356 posts
 
First, I don't think your allowing nearly enough time for your pre-amp tubes to warm up. Give them at least a couple of minutes before switching on the amplifier in the future. Then make sure all of your connections are firm. (I had a cleaning lady dust behind my equipment rack, inadvertantly disconnecting a speaker cable with the result of one "dead" channel). Then check your fuses and tubes. I hope this helps,
warrenh's avatar
warrenh OP
2,299 posts
 
My pre amp is on a constant standby mode. Always toasty. There is a delay of about 20 seconds when I turn it on. When the digital lights go on, it is good to go. My amp also has a standby mode, so it is always toasty, as well. Newbee called it!!
marakanetz's avatar
marakanetz
5,473 posts
 
Dude,
You've probably hassled too much with NOS tubes on ebay...

Is there anywhay for you to check/adjust bias on your amp's power tubes?
warrenh's avatar
warrenh OP
2,299 posts
 
Yo dude, would you translate, please? don't know what you're talking 'bout with NOS tubes on ebay and bias.
More to discover