dedicated line: 10AWG stranded or 2 solid cores?


I'm in the process of installing 2 dedicated power lines. From what I've been reading 10 AWG solid core, like VH Audio's cryoed Romex, would be optimal. However, in this part of the World we don't manufacture that kind of wire and I only found 10 AWG copper solid core monoconductor insulated in PVC, unshielded.

Hence my question: would I be better off by installing 10 AWG stranded cable, or taking 2 10 AWG solid core monoconductors putting them side by side + a stranded cable for ground and use them as if they were one line?

Thank you!
lewinskih01
Lewinskih01,
I'm not sure that it really matters if you use solid or stranded wire for any of the wiring as long as it's 10 gauge, I have not been able to hear a difference.
I'd say the spacing should be between 2 to 3 inches but it's been six years since I've twisted wire. Make sure you buy longer wire then what you actually need because as I mentioned before the twisting consumes wire.
Lewinskih01,

I agree with Lak that twisting the wire (I used 10 gauge solid core for ground, neutral and positive) is a good thing to do. In my case, the twists are 1" apart and then the wire is run through flexible steel conduit to the outlets. The other thing to try and do is to keep each of the dedicated runs less than 50 feet in length - shorter is better as this also helps with reducing effects of RFI/EMF.
thanks Babybear.

My twisted runs will be about 25 feet long, so well under the 50 feet you recommend. Good news!
Tell me more about the flexible steel conduit: what's the purpose? Just conduit or RFI/EMI shielding as well? Do you have the counduit grounded?
Isn't "Greenfield Conduit" solid core wire already twisted in the metal jacket? Black-White-Green all insulated.
The conduit is again useful for helping to reduce the effects of RFI/EMF. Check my system page for a little more info on what I did.