I just put together my Furutech power cord for my Hydra two power conditioner.
So far so good,nothing earth shatteringly different from my other DIY power cord,but quite the difference cost wise in parts.I went with the rhodium 20 amp IEC and 20 amp rhodium recptacle and two meters of their power cable.
It's about a $500.00 investment in parts, but a quarter the cost of another Annaconda.
The Furutech DIY power cord is plugged into a FIM receptacle that is wired directly to the panel with about 4 feet of 10 guage solid core Romex.
For now all I can report is that it is no worse than what I had, I'll give it a few days to settle in and perhaps there will be less demand on the power if this heat wave snaps.
I'm not making excuses, but when the voltage drops nothing sounds good.
So far so good,nothing earth shatteringly different from my other DIY power cord,but quite the difference cost wise in parts.I went with the rhodium 20 amp IEC and 20 amp rhodium recptacle and two meters of their power cable.
It's about a $500.00 investment in parts, but a quarter the cost of another Annaconda.
The Furutech DIY power cord is plugged into a FIM receptacle that is wired directly to the panel with about 4 feet of 10 guage solid core Romex.
For now all I can report is that it is no worse than what I had, I'll give it a few days to settle in and perhaps there will be less demand on the power if this heat wave snaps.
I'm not making excuses, but when the voltage drops nothing sounds good.