System feedback coming thru speakers.....help

I should have mentioned in my previous post- BE SURE to shut off your circuit before doing this or hire a qualified electrician if in doubt.

A 3-prong to 2-prong adapter will probably still provide a ground, if its metal grounding tab or grounding wire is connected to the screw that holds the faceplate of the outlet in place, and provided that the wiring within the walls is enclosed in metal conduit. If you have a multimeter, or a neon-bulb AC tester, you can verify that by checking for the presence of 120 (or so) volts AC between the AC hot pin of the outlet and that ground screw.

From your description of the symptoms, I don't think that AC grounding or feedback have anything to do with the problem. And the fact that it works OK at very low volumes would seem to say that the problem is NOT upstream of the volume control (meaning that it is not being caused by the source component or its interconnect cables, or by preamp circuitry that is ahead of the volume control). Although it would probably be worthwhile to double-check that by trying a different source component, such as the cassette deck.

Some things to consider:

Are you certain that the new biwire cables are connected correctly, and that there are no shorts in the connections or in the cables themselves?

Are you sure that when you heard reasonable sound at low volume settings that you were getting normal stereo separation? It's conceivable to me that a short between channels could produce reasonable sound at low volumes, except that it would be mono, while causing the symptoms you described at higher volumes.

Along the lines of one of Lloyd's comments, but specifically with respect to the power amp, I would consider the possibility that the amp's input jacks may have been dislodged as you were connecting things, such that they lost their connection to the amp's circuit ground.

And, yes, it does seem conceivable to me that a defective tube, or the wrong tube type, or a tube placed in the wrong socket, could account for what you are describing.

Regards,
-- Al

How close is your turntable to the components of your rig & what's the room config. Back in the 70's I had a smallish room & the turntable wasn't isolated enought from the amp/spkrs & perhaps vibration was the culprit & I experienced the same - at least that's what I surmised at the time it & more space & isolation of each piece solved the issue. happy listening!

Ok, update: Yes, I am using a 3 to 2 "cheater" plug/reducer right now. My electrician friend is coming over tomorrow night to look into my electrical scenario. Not pleasant to say the least.
I did open up the pre amp. It looks like tubes 4,5 and 6 are all in correct spot, as I can clearly read the white lettering on the signifying the model. Tubes 1-3 unfortunately are illegible. I did, however, place them in the spots as was indicated on the tube boxes that came with the PV 11 when I purchased it. I have the entire system (just amp, pre and cd/DVD) out in middle of room. No crossed wires, no other issues. I've tried other cables, I've plugged the DVD into a different source on the pre amp......same results.
I made mention Arlie's of it sounding "fine" at lower level......not the case......just at low volumes more difficult to hear the static/thumps.

If the preamp can make the sound smaller or bigger...but the preamp and amp are silent with no source attached to it no matter how loud you turn the preamp...then it has to be source. And is probably not grounding. i did not think grounding would get louder and softer with volume.

Might be your source or your cable in between your source and preamp. Try a different cable. If same, then try another dvd player. Hope the electrician can help.