DIY Speaker wire

Mechans is spot on. I love the sound of heavy gauge , solid core copper wire. If you have not tried, then don't knock it until you try. It has bested all of the highly reviewed and priced speaker cables I have owned over the years. Yes, the stuff you can buy at Home Depot!

Mechans, What gauge solids did you braid? Am I to assume you braided 3 each per binding post? Again I am running these 24'. and there will be a set each split at 1200 htz. What of single wire 10 awg?

I ran 14 gauge and three runs of each for each. Three neg and three positive. I also braided mine. Be sure to get THHN solid core copper.

I don't remember the exact guage but they were easy enough to braid (not really easy they were kinda stiff green jacketed). Just like Grannyring I used 3 insulated solid core wires in each braided leg for the speakers one braid for pos one for neg. Yes I bought the wire at Home Depot, Honestly I thought they sounded really good but couldn't resist all the hype from the cable makers and bought "real" Jena Lab braided copper but aside from the high caliber connectors I think I was equally satisfied with my cheap imitation cable, it was thicker guage than the Jena Lab.

since I have to run 25 feet, might I braid a larger wire, say 12 awg? Also Since they are over a stone floor I thought I would put them into a "wiremold" floor raceway that has 5 tracks made of aluminum. What about polyester expandable sleeving? I've also seen posts where rather than binding posts , solid copper is hammered into a loop.