Amp Shutting Down, need help

Jea48 - I can not thank you enough for your help.

1. No markings on breaker box at all. Building built in the 1970's
2. Outlet is about 40' from breaker box.
3. I was incorrect, there are 4 outlets on the branch but nothing is plugged into them.
4. The White and Black wires connected to the circuit breaker seem to be 10 guage.
5. I plugged the volt meter into the unused receptical next to the one the Cary was pluged into. With nothing else going on the voltage goes from 117.9 to 118.1. When I switched the Cary on the voltage did not change. Nor did it change during the 20 seconds it takes for the 15amp Cary breaker to trip. However when the breaker did trip for a split second the votage meter read 112 volts. I was able to re-create the same readings after 4 tries.

This is my friends theory. He works for the local power company. Let me know your thoughts.

"The breaker is a thermo-magnetic breaker and I think when the amp relays click off after it is done charging the caps, the break in load (which is not a smooth wave either) is sending a fluctuation back out on the incoming power that is causing the breaker to think there is an over current and trip. You should talk with Cary, but the solution may be to use a thermal breaker rather than one that is operated magnetically. The fact that the extension cord solves the problem supports this theory. The extension cord acts like a filter so when the amp relays open, it resists any power fluctuations on the line and therefore limits the magnetic field created on the breaker tripping mechanism."

I just want to listen to music :)

Hmmm, as you stated, it acts the same way from your 15 amp circuit as well as your dedicated 20 amp, yet works fine at Cary and your friends location(s) without the extension cord - when considering your friend's theory.

Jea48: As you know, "inrush" current is typically instantanious - with PS filter caps charged to 95+% within a few seconds, or so, for most high-power amps. Note he's stating the breaker consistantly trips "after 20 seconds", and even from several of his apartment's pre-wired standard 15 amp outlets. His recent noted voltage drop to 112, only at the moment of trip, is curious. For a thermo-magnetic breaker, you'd expect to see sustained high current voltage drop right up until tripping vs the virtually unaffected static 118 - as if the power supply wasn't even pulling current (?).

I just took a look at Cary's online PDF Owners Manual for anything of interest and there's not much to assist.

http://www.caryaudio.com/pdfs/manuals_2012/Model7.250_manual.pdf

4. The White and Black wires connected to the circuit breaker seem to be 10 guage.

Is the breaker a GFCI (Ground Fault Circuit Interrupter) or an AFCI (Arc Fault Circuit Interrupter)? These type of breakers have a test trip push button on them.

When I switched the Cary on the voltage did not change. Nor did it change during the 20 seconds it takes for the 15amp Cary breaker to trip.

Well that is good for the integrity of the branch circuit wiring. That tells me with the load connected the branch circuit maintained the supply voltage with little or no VD, (voltage drop) through the high inrush current cycle.

That also tells me the branch circuit is capable of delivering the inrush current draw of the primary winding of the power transformer.

However when the breaker did trip for a split second the votage meter read 112 volts.

I have a feeling the VD drop happened before the trip.....
Question is what is it and why?

At this point it would be good to hear from Almarg or Ralpf of Atma-Sphere Music Systems.

As for your friends theory he could be onto something.

By chance does your friend have a clamp on amprobe so you could measure the inrush current draw of the amp on startup?

As for the circuit breaker used on the Cary.... Is the switch actually a breaker? The handle trips position and has to be reset? If it is indeed a breaker the more times it is tripped the weaker it becomes.

Just can't beat a fuse for overcurrent protection for audio equipment.....
Jim

Jea48: As you know, "inrush" current is typically instantanious - with PS filter caps charged to 95+% within a few seconds, or so, for most high-power amps.
08-15-12: Metro04

Note he's stating the breaker consistantly trips "after 20 seconds",
08-15-12: Metro04

Metro04,

Good point....

His recent noted voltage drop to 112, only at the moment of trip, is curious.

Agree.....

For a thermo-magnetic breaker, you'd expect to see sustained high current voltage drop right up until tripping vs the virtually unaffected static 118 - as if the power supply wasn't even pulling current (?).

Are we 100% sure what the trip mechanism is?

The fact that the 50' extension cord allows the amp to work without tripping the overcurrent protection is baffling to say the least.

Like I said earlier it could be working as a current limiter... I am not so sure now, that is case...



If Sailcappy lives in a high rise apartment building hard telling what the power quality of the AC power looks like.

I wonder if Sailcappy has talked to the superintendent or head of maintenance about his problem? They may split the cost for a "Power Quality Company" to check out his mains power quality.

Harmonics
http://p3-inc.com/whitepapers/harmonics.pdf
.

"Is the breaker a GFCI (Ground Fault Circuit Interrupter) or an AFCI (Arc Fault Circuit Interrupter)? These type of breakers have a test trip push button on them."

There are no test trip buttons on any of the circuit breakers in the breaker panel.

"As for the circuit breaker used on the Cary.... Is the switch actually a breaker? The handle trips position and has to be reset? If it is indeed a breaker the more times it is tripped the weaker it becomes."

Yes it is an actual breaker as the switch has to be switched back on to put the unit back into standby. I have had it replaced to no avail.

"By chance does your friend have a clamp on amprobe so you could measure the inrush current draw of the amp on startup?
"
He did use one yesterday I have forgotten the outcome and will ask him tomorrow.

I do live in a high rise and my building said and I quote "as long as the breaker is not tripping then we do not concider you to have a problem." So much for living in a "luxury building".