Which resistors to use for KT88 output tubes

Hi Rodman, I don't see any mention of wirewound resistor being quieter than Vishay or Caddock in the link you provided. Is this from your personal experience?

Again, the Vishays and Caddocks I was referring to, are both Metal Films. Read the paper again, in that light. Yes, this has also been my experience.

Wont metal film work just as well on the grids?

Thanks Rodman. I read it again and saw the reference to wirewound resistors.

Based on the schematic of my KT88 amp, I see a 2.2 kohm 2 watt resistor to the control grid, a 100 ohm 5 watt resistor to the screen grid, and 10 ohm 5 watt plate resistor.

Obviously, the 10 ohm resistor should be a wirewound resistor. It will probably also be noninductive as well.

The control grid resistor should be a noninductive wirewound too.

It is the screen grid resistor that should be carbon comp because of its low inductance? Why can't I used a non-inductive wirewound resistor here?

PRC makes very high quality precision wirewound non-inductive power resistors.
http://www.precisionresistor.com/files/PDF/Precision-Power-SM-Series-Wire-Wound-Precision-Resistor.pdf

After noticing Caddock 1W MM215 resistors in some top commercial audio gear, I intend to try this non-inductive model singly and in parallel in a future upgrade. Has anyone here experienced these or perhaps the MS or MV series? Caddock factory direct will build these in custom values.