Anticables Review

All I can suggest is further break-in. I'm trying a pair between my Merlin VSM-MXe's BAM and preamp, and yes at first they sounded rather "steely" and strident, but now I have no complaints at all. The remaining cables in my system are Audience AU24 (including power, interconnect and speaker). Now that they are broken in, I plan to swap and compare them with the AU24s running from my CD player (McCormack UDP-1 Deluxe).

Kontrabass,

The aspect of bass reproduction that depends on different cables is illusory. There are too many factors in the perception of different frequencies, including the source, the amps and the speakers, and most importantly our minds. The science of psychoacoustics tells us that we adapt to sounds and our expectations are met by altering our perceptions. That said, these are fine cables and I believe present the true signal from amplifier to speaker. No "tone controls" with this wire. I don't doubt that there are differences in the "sound" of speaker cables, but pure copper wire in short lengths cannot be a bad thing, except if you sell expensive wire for a living!

Think of it like this: What's the most prevalent form of wiring inside most electronics? That should tell you most of what you need to know.

I use the ANTICABLE speaker cables(wires) in my system with spades. And can only say that there was an increase in detail and depth for my Thiel CS 2.3 speakers. My amp is a McIntosh 206. If the sound immediately sounds offensive or worse to you with a particular brand -CHANGE EM. Different cables gel different with different systems. I use a JL sub and bass is not an issue for me , $80 spent for a 8'pair is the HI FI bargain of the century to me. And these displaced cables that were expensive

I've had anticables for about 2 years--first with Von Schweikert's early speakers that sounded better biwired, then with Emerald Physics CS-2's, and now with VMPS 626R's with several upgrades and a VMPS VSS subwoofer. It took the anticables several weeks to sound their best in the VS speakers. Initially, I liked the highs and mids better with the anticable and I used a home made cat-5 wire for the bass on a recommendation by Albert Von Schweikert because the bass was rather lightweight with the anticables. After a few weeks, I tried the second pair of anticables on the highs and switched the other antis to the bass. I was amazed at the improvement in the bass with anticables now connecting both ends. The same clarity was also there with the EP-2's. Not lightweight or thin, but dynamic and with excellent transparency through the entire spectrum of frequencies. When I got the VMPS 626's, I only needed 1 set but they sounded incredible with the anticables--lively, fun and like you are there. Still, being the typical, 'there might be something reasonable that sounds much better and more impressive looking at that', I tried a used pair of Harmonic Technology Pro 9+ ($1199.00) garden hose sized cables after reading their great reviews--are there any other kind? Upon insertion, the joy, and transparency was gone, although the individual sounds were all very good. I ran that used cable for a solid week non-stop. At the end, a hair better, BUT I reinserted the anticables and all the missing parts came back. They don't look like much, have a long break in time, but they are not coming out again. The rest of my system is Edge amp, Audible Illusions pre, VSE cd/sacd, Avid Diva II table, Origin Live Silver II, and Music Maker III cartridge. Give the cables a good chance. By the way, I wound mine rather tight--10 turns/ft. I seems to sound fine and it allows the springy wire to go where you want it. Bob