Audio envy - dang!


I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC. 

I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.

I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s

Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.

The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”

And that’s just what I did.
last_lemming

The SP14's top end is much sweeter than the 12's.  Apparently the ground wire dissipates energy.  In my system it's a much better cable than the SP12's.  

N

@nutty I have the SP12s and really dig them.What would you say the improvement is between the two cables on a percentage basis?

@nutty I had been asking Cap to make a pair of Model 34 SC, but was able to get SP14s and the prototype ICs. With the new Okta and PCs, this is the best I’ve heard from AE

cd45123 I completly agree with your findings.

rlb61 In my system, the new SP14’s are markedly better and different than the 12’s and worth the investment.  I Would encourage you to consult with Cap for more details and your systems needs.

N