Behringer DEQ2496 HELP


After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
honest1
That article suggests doing some things I haven't figured out how to do. For example, how do you overlay multiple target curves? And create Par EQ settings (he says do it in feddback eliminator) and overlay them as well?
Another question. Does it matter if the DEQ is before the pre-amp or after? Right now it's between my pre-amp & amp. I'm not using it as a DAC because I don't want to mess with the amazing sound from my Sony/TRL 900. But if I move it before my pre-amp I could use it as a DAC for my satellite receiver and my Sqeezebox. Any reason NOT to move it upstream?
If you use DEQ2496's analog output, you are using its DAC. If you use its analog input, you are also using its ADC (maybe the same CODEC chip as the DAC).

Only way to get around its DAC is using it in the digital domain only -- digital in and out, with an external DAC.
Ecruz...If you move it between the CDP and the preamp you can't use it for any other source. If you do move it up you should try feeding it digital from your CDP. Your output from the Behringer will be through its D/A anyway, so why run the signal through an extra D/A in the Sony and an A/D in the Behringer?