Bias adjustment

@OP, 
That is a bummer. FWIW, I would contact Ralph Karsten (atmasphere).
I'd bet dollars to donuts that he could help you diagnose the issue.
Bob

Thank you guys, for your input. I'll take a look at some of your suggestions. Have a nice weekend.

DMM or Analog

A good DMM Digital MultiMeter will cost 30-75 dollars. Self calibrate, there is no analog issues as with stick meters. Analog meters are not accurate, they have to be calibrated with a DMM, so why waste your money, your time, or you breath? If your lucky, 2-3 years. In oil for vibration control, still 2-3 years, but normally can be calibrated, with a DMM. Analog looks good, but really don't trust them...

Digital SELF Calibrates. or battery change time, one of the features.

There is no arguing with the numbers then.  Normally when you burn out a valve, burn it up, use it up prematurally, it normally points to over bias. 
You, need to know, supply and demand go hand in hand, with any amp, valve amps, more so.  Maintain 120 vac.  Get good valves, well matched signal and power valves. Use a DMM and you'll be happy. You can tell the tec you DID bias the tubes correctly. But you'll find out they were probably correct...

Regards

BTW I got a pair of great DMM from PE, 49.00 each, will tell you the numbers through your phone. Just as good as my Field Flutes just not as rugged, or as visible (orange).

Regards

@ richfrank

I know what I read on the VOM and it was reading 80 mA as it should be,

Shouldn’t the bias be set at 75mA as the manual says?

Bias Adjustment
Set bias for both sides of the amplifier to 75mA

As oldhvymec mentioned in his post is the meter a DMM, digital multi meter? If the meter is a really cheap one its accuracy may not be all that good.
Can you provide a Web Link for the meter you have?

Just curious, how many hours are on the KT 88 tubes. General rule for power tubes life is around 1500 to 2000 hours.

.