2. speakers
  3. 177861-166623

custom made speaker stand legtips - rubber or metal - not good vibration

I finally had my preferred speaker stands made but it came with a wooden "stick". as shown on the picture. I wanted to put an rubber tip to the end and to secure it, I put a screw in it. Now the screw is touching the floor. (Speakers: Dynaudio Evoke 20) 

Questions:

  • Should I recess the screw so that the "rubber touches the floor?
  • Should I put something on the floor between the speaker leg tips and the floor (hardwood floor on concrete) - like a soft pad?
  • Entirely a bad idea for both rubber and screw?

grislybutter
ghdprentice
6,970 posts
 

Nice. I would do anything you can to stabilize and ridgidify the stands. All my tripod telescope mounts have ridged connections between the legs about 25% down from the top. I could see the rubber at the bottom adding a bit of rigidity to the design by holding to the floor. I would try it with screws in further. 
 

Unfortunately I think you are in a situation that requires experimentation.

yogiboy's avatar
yogiboy
5,674 posts
 
  • Should I recess the screw so that the "rubber touches the floor?
  • Yes!!
erik_squires
16,061 posts
 

You are way overthinking this.  Simple felt pads will work. 

4krowme's avatar
4krowme
542 posts
 

If the screw cannot be sufficiently recessed, then perhaps using an adhesive would be the answer. I go round and round with this sort of problem with chairs, but that turns out to be a user problem to begin with. Fortunately, once you the position for the speakers set, you will be done. I do like what was mentioned about a support 25% of the way down the legs. Someone who knows about telescopes has knowledge that nicely overlaps this topic.

grislybutter OP
3,009 posts
 

@ghdprentice 

about the cross bars, if that's what you meant.... function over aesthetics over function? Hm..... :)

@yogiboy  @4krowme  - recessed it is!

More to discover