2. speakers
  3. 180340-177790

Estate sale Fuselier speakers for $370 but I know nothing about them.

So I found these four Fuselier speakers for $370 at an estate sale. They look amazing and from everything I've seen around this forum the creator seemed to know what he was doing.  But I'm just getting into this hobby and I've come across these and I have no clue as to whether they are any good or whether they even work. Any thoughts on how I should proceed or steps I should take? Or should I just buy them and hope for the best? 

 

Here is a photo of them: 

 

Thanks so much.  

thatguyyouknow
mesch
3,520 posts
 

I was asking about the volume controls on back of the Rotel amplifier. 

 

 

dill
2,539 posts
 

Yes, mesch has a good question. Make sure the level controls, on the rear of the Rotel flanking the RCA plugs are turned up all the way.

thatguyyouknow OP
29 posts
 

The level controls are turned up to the maximum. They can be turned and the volume can go down, but they cannot be turned to make the volume go up. They are at their maximum. 

mesch
3,520 posts
 

Given that the volume issue is the same via the phono input and the tuner and it also seems that the gain from the Eskinsin is not much higher, only providing 3dB more gain when used direct into amplifier, I suspect that the amplifier is defective, possibly in the input stage. What is output voltage on the Eskinsin?

dill
2,539 posts
 

I assume you have the Rotel hooked up to the pre-out RCA jacks on the rear of the Kenwood. Have you switched from normal to separate?

More to discover