Fozgometer

Ooops, that's "your" description. I had started with a different train of thought and then changed everything but "you're". 8-)

There are two schools of thought with regard to the endpoint of azimuth adjustment. One says to go for the least amount of crosstalk, in which case I have found over many years (using the Signet Cartridge Analyzer which reads out in "db") that the amount of crosstalk will not be equal in both channels. The other says to go for equal amounts of crosstalk in both channels, even if in doing so you have to sacrifice the absolute best values for crosstalk, which is nearly always the case. There is no right or wrong in choosing either endpoint.

I presume the Foz reads crosstalk at 1kHz. Yes? If so, what do the numbers "17" and "19" mean? If the readout is in db, then it is usually a negative number indicating the level of crosstalk below 0 db, when the channel being measured is set to 0 db. In that case, one typically sees better than -20db at 1kHz (meaning a number more negative than -20).

Lew, the manual states that channel separation is what's being measured. Also: "The readings are virtually independent of overall signal levels, and can be made with a wide range of input signals without effecting accuracy."

So your comment about what correct azimuth entails is consistent with using the Fozgometer for alignment. Try to get both the best balance between channels and the highest separation in each channel. As you also mention, the two are probably synonymous in a perfect world, but I've found that sometimes it's a compromise between the best separation and the best balance. But which should have priority is not clear to me and I've biased the alignment in favor of trying to get channel separation in better balance while maintaining the best separation value in the lower of the two channels. Does that seem reasonable? (Reasonable or not, it sounds mighty fine. :-)

It would be helpful if Mr. Fosgate and Musical Surroundings were a bit more thorough in describing what the goals are and how to get there.

Regards,
Tom

Tom...actually its very rewarding when you listen to the final results and how each of the parameters effect the overall sound. ...and you really only have to do the whole job once (until the next cartridge comes along..)

Stingreen, I may try a uni-pivot tonearm some day. But for now, it's gimbals, man.

Best,
Tom