Happen to you? Gear chasing because the fundamentals were wrong.


Gear chasing and swapping can be a real joy or a real pain. 
The search for "better" or just the search for the "right fit" or sound.
One thing I've learned (with some difficulty) is that there are some fundamentals which have to be in place if anything else is going to be accurately assessed.

Of these, amp-speaker synergy and room acoustics were the most obvious factors I neglected. Noise and isolation were also missed as critical, early on. I blamed components which really were not the cause or the solution to the situation because I was missing the fundamentals.

I'm curious to hear anecdotes of your discovery.

What fundamental did you fail to pay attention to which caused you to chase gear unnecessarily?

Hopefully, these stories will be instructive, especially for newer audiophiles.

128x128hilde45

What fundamentals? Far too many and I should know better!

- Buying high end speakers with low end design

- Believing speakers needed to be big

- Believing subs are mainly for movies

- Thinking that my electronics, but mainly my amps were either the problem or the solution

- Accepting at some point that I fundamentally did not understand how what came out of my speakers eventually got to my ears, and what it did when it got there

- Realizing that audio dealers, at least the ones in my area of which there are many, don't know what they are talking about 95% of the time.

Great stuff! Thanks. Keep it coming.

@nonoise 

To be honest, when I first started out I fell for the hype when it comes to amps, power ratings and the like. Add speaker myths about efficiency and the dos and don'ts in all things audio. It was a learning curve for me.

Me too. I also didn't understand about impedance curves and phase angles.

Not understanding the frequency spectrum. Thinking that a flat room response is the ultimate pinnacle.  We all know how annoying peaks in the bass region can be, but I have since discovered that small peaks (around 3 db) at certain frequencies, in the mid’s and low mid’s can add a richness to vocals and that certain dips in the mid’s can remove a hollowness from vocals that can show up from time to time. A peak in the upper mid’s can add a very striking presence to vocals, lead guitar, acoustic guitar, upper register wind instruments and snare drum strikes. Strategic dips in the upper mid’s and highs can remove the hard edges that you sometimes hear on vocals and can diminish background noise that you don’t even know is there until it’s gone, which reveals a noticeable amount of clarity and detail and creates more air around each instrument. Lastly a peak in the upper high’s that can add a shimmer to cymbals that gives them an almost crystal like quality.

A couple of times poor amplifier choices left me feeling unhappy, but things are right as rain these days, so all is well.

Regards,

Dan

Thanks very interesting post... I live the same experience... A room with a flat response is hell not heaven.. It is not even possible in most room anyway..

Not understanding the frequency spectrum. Thinking that a flat room response is the ultimate pinnacle. We all know how annoying peaks in the bass region can be, but I have since discovered that small peaks (around 3 db) at certain frequencies, in the mid’s and low mid’s can add a richness to vocals and that certain dips in the mid’s can remove a hollowness from vocals that can show up from time to time. A peak in the upper mid’s can add a very striking presence to vocals, lead guitar, acoustic guitar, upper register wind instruments and snare drum strikes. Strategic dips in the upper mid’s and highs can remove the hard edges that you sometimes hear on vocals and can diminish background noise that you don’t even know is there until it’s gone, which reveals a noticeable amount of clarity and detail and creates more air around each instrument. Lastly a peak in the upper high’s that can add a shimmer to cymbals that gives them an almost crystal like quality.