2. amps-preamps
  3. 143557-20253

How to DIY yourself very nice Class D monoblocks

If you want to know what the hoopla is about Class D and want to put together a very nice sounding kit I have a starter recommendation for you.

Go to Parts Express and search for "ICEPower ASP"
Next, look online for Ghent Audio. They make many sets of cases.

You'll need a high power soldering iron, and screw skills.
Between those two, you can put together a very nice monoblock for around $500 a piece.

I highly recommend both. I have no financial interest in either. 
You may need wiring kits, so make sure to order appropriately.
erik_squires
Post removed 
evelyn1
51 posts
 
Thanks to all on all the posts here. After doing some researching and reading the posts above, I pulled the trigger on Hypex nCore NC400 mono kit (x2). I'm not an electronic engineer but I figured that if Bel Canto went with Hypex on their recents amps, then they are probably better. The pair of kits include everything, require no soldering, and cost $1540.00 in US dollars including overseas shipping. I can afford taking a chance at this price and have a feeling I made a good decision. I'll return here when I get this installed and let you know how it compares to Krell FPB300. Thanx again, Frank
erik_squires OP
16,042 posts
 
Hey @evelyn1

Let us know what you think!

Best,
E
ketchup
698 posts
 
What are you guys doing to get around the low input impedance of the ASP modules? I think it’s around 7-8K ohms. My preamp’s output impedance is 200 ohms. That's not good, right?
erik_squires OP
16,042 posts
 
What are you guys doing to get around the low input impedance of the ASP modules? I think it’s around 7-8K ohms. My preamp’s output impedance is 200 ohms. That's not good, right?

Hi @Ketchup,
200 should be fine!! It's usually recommended that there be a 10:1 ratio, so you'd have more than enough.

Best,
E


More to discover