In need of some Amplifier advice. Is therereally any point in it with my current setup?


Hello. I have posted in the past, but have since learned a little bit more from reading audio forums, and doing some research and have come to somewhat of a juncture. 

I figure I could "stair step" up on my own and enjoy the ride, or, ask those who have most likely been where i am before and skip a few steps =). 

My current setup consists of a Yamaha adventage-A3070 AV receiver (150wattsx8ohms 2chd), and 2 Polk LSIM707 towers. 

I've been looking at used Classe amps here on audiogon, or possibly a new parasound Halo A21 power aplifier,  and have thought about purchasing them. 

My question is, would my Yamaha advantage 3070 even be a sufficient pre-amp? It has pre-outs for all channels, and it also has an ess sabre DAC for my digital flac files. Or would using the Yamaha as a pre completely destroy the sound of the power amplifier? Essentially wasting $1,000-$3,000. 

My other question is pretty obvious. Should I trade up, just spend the $1,000-$3,000 on better set of speakers I've been eye balling like  the EMT-LFT8s, and stick with the Yamaha receiver's power for now. 

If it were you. What would you do? 


moskaudio
@audiothesis, Oh don't worry. I acquired 2 new polk LSIM707s, 2 new polk 703s, a polk lsi706c, AND a new Yamaha adventage 3070a receiver for $2,800 on a deal earlier this year from Adorama. 

I know they definitely aren't worth their MSRP and wouldn't pay anything close to it. 

I use the 703s in my office with a rotel receiver. the 706c is still sitting in its box new, I will probably sell it as I don't have an interest in 5.1 or 7.1 audio. 

And yes, My living room is roughly 20'x18'. I've got plenty of space for positioning. 
If you can drive to Dallas, TX. , there is a Vandersteen dealer.
As 2psyop posted, try and audition as many speakers as you can. Once you find a 'sound' that sings to you, then you can start making decisions on the rest of the equipment.
Yamaha, if I recall, is a fairly neutral sounding amp. So, with 150 wpc, I think you have enough power for most speakers on the market.
B
I sent you a PM through the marketplace.  I'm in Arlington, TX, so not too far away.  I've got some ideas/advice, but I have many questions that would simply be easier via phone.
gdnrbob - its less about the power and more about control and noise floor.  IMO no receiver should ever be at the helm of a 2 channel system, though I completely understand why it is in this situation and can't fault it at all.  The package was a stellar deal.