Hmmm. @moskaudio, you do realize the setup I described above allows you to keep the AVR and pure stereo components (amp and preamp) completely separate within the same system without having to swap any interconnects or cables, right? That's the whole point of this. If you're having to swap wires to switch between stereo and HT there's something amiss here. All that's necessary in the setup I described is to change the input on the stereo preamp to switch between the stereo and HT, and you'd be using your "good" speakers (when you get them) for both stereo and HT. No 707s required. The AVR is completely out of the system for stereo and only involved when doing video related stuff -- nothing cheap about this at all. Not sure I was clear on this point.
In need of some Amplifier advice. Is therereally any point in it with my current setup?
Hello. I have posted in the past, but have since learned a little bit more from reading audio forums, and doing some research and have come to somewhat of a juncture.
I figure I could "stair step" up on my own and enjoy the ride, or, ask those who have most likely been where i am before and skip a few steps =).
My current setup consists of a Yamaha adventage-A3070 AV receiver (150wattsx8ohms 2chd), and 2 Polk LSIM707 towers.
I've been looking at used Classe amps here on audiogon, or possibly a new parasound Halo A21 power aplifier, and have thought about purchasing them.
My question is, would my Yamaha advantage 3070 even be a sufficient pre-amp? It has pre-outs for all channels, and it also has an ess sabre DAC for my digital flac files. Or would using the Yamaha as a pre completely destroy the sound of the power amplifier? Essentially wasting $1,000-$3,000.
My other question is pretty obvious. Should I trade up, just spend the $1,000-$3,000 on better set of speakers I've been eye balling like the EMT-LFT8s, and stick with the Yamaha receiver's power for now.
If it were you. What would you do?
I figure I could "stair step" up on my own and enjoy the ride, or, ask those who have most likely been where i am before and skip a few steps =).
My current setup consists of a Yamaha adventage-A3070 AV receiver (150wattsx8ohms 2chd), and 2 Polk LSIM707 towers.
I've been looking at used Classe amps here on audiogon, or possibly a new parasound Halo A21 power aplifier, and have thought about purchasing them.
My question is, would my Yamaha advantage 3070 even be a sufficient pre-amp? It has pre-outs for all channels, and it also has an ess sabre DAC for my digital flac files. Or would using the Yamaha as a pre completely destroy the sound of the power amplifier? Essentially wasting $1,000-$3,000.
My other question is pretty obvious. Should I trade up, just spend the $1,000-$3,000 on better set of speakers I've been eye balling like the EMT-LFT8s, and stick with the Yamaha receiver's power for now.
If it were you. What would you do?
- ...
- 52 posts total
- 52 posts total