In wall AC cables

Honestly the normally recommended sizes is best. Having too low an impedance will encourage more noise going back and forth in the wires.

You may want to run a circuit for digital, and another for analog.

To get uber-fancy run a 220V 60 AMP line and dedicate 220->120 V transformers in the room. That's the fanciest with "normal" electricity.  The transformers will reduce line noise contaimination from inside and outside.

If instead you want to get fancy with re-generation PurePower and PS Audio are top tier, and Furman wiht LiFT and SMP (pro is cheaper) are a worthwhile value.

Best,


Erik

erik_squires

Honestly the normally recommended sizes is best. Having too low an impedance will encourage more noise going back and forth in the wires ... To get uber-fancy run a 220V 60 AMP line and dedicate 220->120 V transformers in the room.

Using "recommended sizes," or using the minimum gauge to meet code, is often not the best approach. By de-rating the wire, you'll reduce or eliminate voltage drop and improve the quality of your ground connection. That can yield greatly improved results. Using minimum wire gauge as a way to reduce noise is introducing a remedy that may be as bad or worse than the disease.

As far as I know, a 220V line is not an option for residential use in the US. Erik may have meant to suggest 240V, but you'll absolutely want to check with local officials before considering that - I think it may be against code in some locations. If you want to install isolation xformers, one option is to keep them out of the room and install them at or near the service panel.

I ran 3 lines. One for amp, one for pre and TT, one for digital sources. Used 10ga romex. 

There are other safety issues involved with overrating cables in that they may increase the minimum break current of circuit breakers.

Voltage drop should be negligible.

Now I think you misunderstood. First, 220V = 240V, really just about the same thing here. It will probably measure closer to 240 but we call it 220.  Second, residential service in the US usually IS 220 with a center tap, which gives the nominal 110V (Again, closer to 120V, it's just what we call it).  220 Service is often used for electric ranges, air conditioners, etc.

Secondly, I wasn't recommending he use 220 outlets, but that he run 220 service to a transformer ($200 - $500 ish) professionally installed in the room. This would give the least voltage drop and highest noise rejection possible.

None are really my preference, but if you want to get that fancy with room electricity that's my suggestion.

YMMV.

Best,


Erik