Integrated's equipped for biwiring??

Creek 5350SE.

Actually any integrated, if the biwire speaker cables are combined at the speaker end. Usually you can combine two sets of spapes on one terminal anyway. The Creek has two pairs. So does the YBA Integre DT. The Integre has a dedicated high frequency terminal, tuned for more of a more tube sound.

I would think any integrated should work as Sugarbrie said. I bi-wired B&W N804's from a MF A300 integrated (just one set of terminals). Works fine.

Interestingly enough, this weekend I was hooking up some Boston Acoustics SubSat 7's (2 satellites with sub) that were sitting around in the basement for my daughter (moving up from a boom box in her room). Wires run seperately to the two satellites and the subwoofer - sort of bi-wiring, I suppose. Even though the amp I was hooking it up to had two sets of terminals, the BA instructions specifically said to hook up both the satellites and sub to the same terminals and not different sets.

Anyone have a clue why?

Bill

THE DENON PMA-2000R.THIS IS ONE AWESOME INTEGRATED AMP.(44 LBS.)IT IS SET UP FOR BI-WIRING.(M.S.R.P.$999.00)NEW.

Bill - may have something to do with the sub. Bi-wire is normally for mains only.