2. tech-talk
  3. 167090-525

Main vs. sub panel for dedicated lines

I am building a second home on my property. Will have a dedicated audio room. I will be routing 2 or 3 dedicated lines for my audio system. The high current devices for the home will be run off the main panel. I will install a sub panel supplied by the main to accommodate power for 2 bedrooms and a 1/2 bathroom.  

Question, should I run my dedicated lines off the main or the sub panel? I could move some of the high current devices to the sub panel if needed.

Thanks in advance for advice. 
mesch
audioguy85's avatar
audioguy85
2,018 posts
 
What difference does it make? The sub panel is still receiving power from the main panel. Just go to main panel and fit a new 20 amp breaker, or if no room a piggy back breaker. Then use 20 amp 12 gage romex, the yellow jacketed romex. If you like making more work for yourself, then use 10 gage romex...to me, no benefit and way to stiff, over kill....then install a stand alone receptacle contained in a handy box. I’d recommend the audioquest nrg Edison receptacle and cover plate, excellent quality. This is an easy diy project. If the main panel is of 200 amp service, I’m having a hard time seeing the need to add a sub panel. You are in no way going to tax the main panel by running audio equipment.
jea48
4,453 posts
 
lowrider574,353 posts   

06-03-2021  
 3:04pm


Question: why are two ground rods used?

Hi @lowrider57

From one of my above posts:
06-02-2021
8:24am

Minimum required number of driven ground rods for the main service panel technically is one, * IF *, the ground rod to soil resistance is 25 ohms or less.
How can the electrician know for sure if it is 25 ohms or less? With testing equipment that is made to test it. If an electrical inspector sees only one ground he will ask to see a print out of the test. It is cheaper by far for the electrician to just drive two ground rods and be done with it.

I am curious what’s going on with the two ground rods in the basement. Sure would like to know. 3 ft apart? Not 6 ft apart? Are the two rods connected together by a bare #6 solid copper wire?

How about the old ground rod that was used for the old service? Did the electrician use it for the new main electrical service as one rod and the new rod(s) in the basement for the other? Curiosity killed the Cat.....

Best regards
Jim.
lowrider57's avatar
lowrider57
5,417 posts
 
@jea48 
Sure, I'll check for you. 
Are the two rods connected together by a bare #6 solid copper wire?
I don't recall seeing them connected. Can each rod individually be connected to ground in the main panel? 



jea48
4,453 posts
 
Can each rod individually be connected to ground in the main panel?
Sure. Especially for your situation. Both rods ground wires would connect to the service entrance neutral conductor neutral bar.
.
mesch OP
3,513 posts
 
Ground the sub panel to the main which is grounded to earth. 
More to discover