Thanks! I am currently away from home and will return by end of the month. I will have my electrician help me install the sub panel. I will use it for my audio system. I will get back to everyone once this has been accomplished.
Main vs. sub panel for dedicated lines
I am building a second home on my property. Will have a dedicated audio room. I will be routing 2 or 3 dedicated lines for my audio system. The high current devices for the home will be run off the main panel. I will install a sub panel supplied by the main to accommodate power for 2 bedrooms and a 1/2 bathroom.
Question, should I run my dedicated lines off the main or the sub panel? I could move some of the high current devices to the sub panel if needed.
Thanks in advance for advice.
Question, should I run my dedicated lines off the main or the sub panel? I could move some of the high current devices to the sub panel if needed.
Thanks in advance for advice.
- ...
- 38 posts total
@jea48 Hi Jim, the service I mentioned is the one where you kindly offered advice. Installation was from the drop to a new meter, then inside to a Square D 100A panel, 60A subpanel. This is a small Philly rowhome where outside the house is pavement. Now don’t freak out, this might be Philadelphia code; both grounding rods are drilled into the basement cement floor near the rear wall. They’re 3’ apart, sunk into mother earth. I can only see one rod which is wired to the main panel. The 2nd rod is obscured behind my washer/dryer. I will look for the wire. Question: why are two ground rods used? I’m guessing the second rod isn’t wired to the subpanel because the main panel is ground, correct? |
What difference does it make? The sub panel is still receiving power from the main panel. Just go to main panel and fit a new 20 amp breaker, or if no room a piggy back breaker. Then use 20 amp 12 gage romex, the yellow jacketed romex. If you like making more work for yourself, then use 10 gage romex...to me, no benefit and way to stiff, over kill....then install a stand alone receptacle contained in a handy box. I’d recommend the audioquest nrg Edison receptacle and cover plate, excellent quality. This is an easy diy project. If the main panel is of 200 amp service, I’m having a hard time seeing the need to add a sub panel. You are in no way going to tax the main panel by running audio equipment. |
lowrider574,353 posts Hi @lowrider57 From one of my above posts: 06-02-2021 8:24am Minimum required number of driven ground rods for the main service panel technically is one, * IF *, the ground rod to soil resistance is 25 ohms or less. I am curious what’s going on with the two ground rods in the basement. Sure would like to know. 3 ft apart? Not 6 ft apart? Are the two rods connected together by a bare #6 solid copper wire? How about the old ground rod that was used for the old service? Did the electrician use it for the new main electrical service as one rod and the new rod(s) in the basement for the other? Curiosity killed the Cat..... Best regards Jim. |
- 38 posts total