MC Cartridge break-in?


Is there a break-in period for Koetsu cartridges? I am using a new Koetsu which sounds somewhat harsh and throws a narrow soundstage...should this cartridge smooth out and open up over a period of time?
Thanks
wda
WDa, yes definitely. The harsh sound is typical. Mind you, you need to do a differential diagnosis as far as VTA is concerned. See that you have that right. But after about 19 hours of playing, you will notice a change in the sound, more bloom, better dynamics, better stage. Be patient. It can take weeks! Regards,
10 hours minimum, i'd say. you should notice the biggest difference after that minimal time, and then the time increments really start to spread out. ie like, 50 hours and so on. i can't imagine it needing more break in any further than 150 or so before it is finished.

either way, though, the first 10 hours are the biggest.
I think Lazarus is right on for most cartridges. However, I have owned a few that still sounded pretty bad even at 30 hours of break in. The other thing to keep in mind is cartridge loading as well as VTA. Both can play a major roll in soundstage and openness. The nominal cartridge loading is just that--"nominal" and almost never optimal. You have to experiment a while to get the best sound. However, get at least 10 or more hours on the cartridge, because any changes you make during the biggest changes during break in will likely be changed again.
I don't really know. Before I had a Goldmund arm, which has a repeat, so I could use an old decrepid LP, I didn't like, I simply had to exercise patience and waited until the music began to bloom.
Try the Cardas Burn In disc. I'm not sure I got the name exactly right, but it has white noise tracks which are actually one continuous groove which can play indefinately. These discs are pressed on special hard, durable vinyl for repeated use. The disc also has many other diagnostic tracks which are quite useful.
Hi,
I have 3 or 4 Koetsu, and currently breaking in my Urushi newly retipped.

My experience it takes about 60 hours (about 80 LP sides) to get the sound almost right. Almost 200 hours to really break in the Koetsu fully.

Make sure loading is 100 ohm. 47Kohm will be quite bright. Tracking for most Koetsu between 1.8 to 2.0 VTF. VTA is almost level, with slight dip to the rear of the arm tube.

www.extremephono.com
Here's a tip from the Psychic:

Buy a cheap (99 cents) 12 inch rap or club music single, 45 RPM if possible. Use it to break in the cartridge (make sure the volume is way down!). I play it about 4-5 times per side each day for the first few days and that really shakes them loose...