So far as I could tell when playing with it, the magnet is a simple disc type; the whole thing is the magnet. So I would have expected that both sides are magnetic. Maybe when you remounted it the first time, the orientation between it and the Hall sensor was a hair off. In flipping it over, you may have fixed that problem without realizing it. Otherwise, I dunno. Bill would know. I gather he did not think that you or he needed to consider the Hall sensor as the source of the problem. C'est la vie.
Phoenix Engineering - Falcon - stopped working
This is a day I've been dreading ever since PE shut it's doors. I've been enjoying the device with my HW-19 ever since PE started offering them to the public several years ago.
It happened yesterday after I put the Falcon in stand-by mode to flip a record I was playing. It didn't turn back on like normal, no lights, no nothin'. I then reset it to factory defaults and it responded to that. Lights turned on and all the switches were responding like normal. I was only relieved for a few seconds when I realized the motor wasn't spinning.
I have verified the motor works on it's own, so I can rule that out.
Is there anything inside the Falcon that would burn out and cause this issue?
The Rouadrunner unit is showing me that the motor, by itself, spins at lowly 31.xxx. I'm lowly now.
ANY help would be greatly appreciated.
-Mike
It happened yesterday after I put the Falcon in stand-by mode to flip a record I was playing. It didn't turn back on like normal, no lights, no nothin'. I then reset it to factory defaults and it responded to that. Lights turned on and all the switches were responding like normal. I was only relieved for a few seconds when I realized the motor wasn't spinning.
I have verified the motor works on it's own, so I can rule that out.
Is there anything inside the Falcon that would burn out and cause this issue?
The Rouadrunner unit is showing me that the motor, by itself, spins at lowly 31.xxx. I'm lowly now.
ANY help would be greatly appreciated.
-Mike
- ...
- 10 posts total
- 10 posts total