oh man…seeing Erik defend Pass I had to pinch myself to make sure I was awake…just kidding… @silverfoxvtx1800 stop trolling. Angela amps looked interesting to you but Pass Labs amps look odd because you saw a ribbon cable? You don’t think it’s odd to see gallons of melted breast implants dumped over the shitty point to point spaghetti that gilbert puts in his amps? Now he’s wearing a skirt and calls himself Angela? Thanks bud, I’ll stick with Pass. |
Those ribbon cables are most likely used for the front panel meter, That meter measures current at the output stage so it appears each wire in the ribbon picks up the voltage from a transistor (probably across the emitter resistor) to do the conversion. Since there are a lot of transistors, it is much neater (and cheaper) to run circuit traces to the transistors and then gather them at a connector for a ribbon cable. Or else there would be a bird's nest of conventional wires if they were soldered point to point.. |
I’ve never had anything negative to say about Nelson Pass, the quality of his equipment construction or his business practices. I appreciate how open Nelson has been about his thoughts in amplifier design, and amplifier / speaker integration via seminars and published writing and his willingness to share with the DIY community via FirstWatt. He makes a number of aesthetic choices when it comes to the sound of his preamp and amps which simultaneously have gotten his gear a large following and which does not work for me. It isn’t tribal. |
Emailed Nelson and we talked about ribbon cabling, very nice of him to get right back to me…all is good..the reason I was concerned is I have a Pass XA-25 coming today and the ribbon cabling jumped out at me when I looked under the hood…My Primaluna amp died and didn’t have a spare amp..didn’t know I was trolling… ‘thanks for the help |
