Single vs Bi-wire Speaker Cable

I opted for as true bi-wire. Van den Hul Revelation - four individual runs per channel. Martin Colloms used this wire when reviewing the speakers that I currently own and these do the trick for me. If single wire is so superior why do speaker manufacturers fit four terminals ??. I have bi-amped in the past and if I could afford another power amp, I would probably do so again.

I tried a bi-wire setup and found it made no difference so I went with some very good speaker cables and same brand jumpers. FWIW

Good cables wired to the bass terminals with good jumpers to the treble! 

I was drawn to Bi-wire; looked it up in Get Better Sound and went with it on my former Marantz / B&W (IA/Speaker) 2 channel speaker combo.  I was never able to "measure" an improvement, but it gave me peace of mind.

I've since upgraded to a McIntosh IA with Dynaudio speakers; neither of these offer the option to connect by Bi-wire.  So I guess if the better components don't see an advantage, then its probably just fine to do without.  But I'd probably still do it if the option existed 😉

I use William Tell Zero and it is fabulous.  That said, if you choose the single wire and jumper path, using William Tell Zero, Audioquest also sells high-quality jumpers that you can buy either as silver or copper wire.  The terminations are your choice of either spade or banana.  They are 8" in length.  Both of these jumpers use the 500 series of terminations.  The Audioquest website will show you all of these products.

Best to you.