A point to consider in going from the LS50 to one of the high sensitivity speakers that have been discussed is that if you are using a digital source (as opposed to or in addition to LPs), the somewhat highish gain of your integrated amp (the gain of the Brio-r from its line-level inputs can be calculated to be about 40 db) might result in having to utilize the volume control at undesirably low settings (where channel balance and/or resolution of volume adjustment may be compromised).
As a rough ballpark approximation in this case figure on the volume control being used at a position that is around 90 degrees of rotation below where you are presently using it. Although less than a 90 degree difference if you are already using the control in the lower part of its range.
Good luck. Regards,
-- Al
As a rough ballpark approximation in this case figure on the volume control being used at a position that is around 90 degrees of rotation below where you are presently using it. Although less than a 90 degree difference if you are already using the control in the lower part of its range.
Good luck. Regards,
-- Al