True 8 Gage banana plugs

I’m using 8 gage, oxygen-free cable but can’t find any banana plugs that truly accommodate this thick wire. Some claim they do, but don’t. Does anyone know where to buy these? Can’t find them on the web anywhere. Thanks. 


Here you go - tellurium copper direct-plated with pure 24 carat gold, spec’ed to accept up to 7awg wire, which is one size larger than you need.

Use naked BFA style. they will take full diameter and make better connection with your female binding post. That is all I use.



Use 2 or 3 layers of heat shrink to make a gripping location.  


why are you using 8 gauge? seriously over sized for the use.

your not welding with them are you? you do realize its probably 18-24 gauge on the other side of the binding posts, both ends......

your not pumping 40amps into a speaker are you? 

This occurred to me; internal wiring is much smaller. However, my run from the amp is long and I have five drivers on each channel. It already sounds better. Good point, however. 

Check any of the Furutech banana plugs they will take up to 5.5mm wire diameter, which is around 4 ga. so 8 ga. wire is an easy fir in the Furutech banana plugs either straight or 90 degree also the 90 degree plugs spread open when you tighten the screw so that they stay tight in your amp or speakers.

they are somewhat expensive but your get what you pay for, they are top quality plugs.FP-202(R)/(G) | FURUTECH

WBT-0644 banana plugs (they have newer version of the 0644 but terribly expensive)

Or you can get some Chinese brand Audiocrast banana plugs 10mm ID for $15 on amazon or ebay.... identical!!! i don't find any audible difference... only 20x cheaper than the WBT